论文信息 - A round robin test on flash thermography

A round robin test on flash thermography

A round robin test on flash thermography was organized within the scope of a standardization research project. This test gives information on reliability, comparability and efficiency of different testing situations. Data recorded on metal and CFRP test specimens with flat bottom holes (FBH) were analysed by evaluating the detectability and by calculating the signal-to-noise ratio (SNR) of the defect signatures as a function of defect parameters. For the investigation of the influence of material properties on the spatial resolution as well as on penetration depth, test specimens made of steel and copper with crossed notches and a notch ramp were constructed and investigated. Here, the minimum resolvable notch distance and the maximum detectable depth of the ramp were analysed.

[1] Steven M. Shepard,et al. Advances in pulsed thermography , 2001, SPIE Defense + Commercial Sensing.

[2] Xavier Maldague,et al. Round Robin comparison II of the capabilities of various thermographic techniques in the detection of defects in carbon fibre composites , 2000 .

[3] Igor Kryukov,et al. A round robin test of flash thermography of CFRP and metal structures , 2015 .

[4] V. P. Vavilov,et al. Review of pulsed thermal NDT: Physical principles, theory and data processing , 2015 .

[5] X. Maldaguea,et al. Advances in Pulsed Phase Thermography , 2001 .

[6] Ermanno G. Grinzato,et al. Infrared thermographic detection and characterisation of impact damage in carbon fibre composites: results of the round robin test , 1998 .

[7] Dietmar Meinel,et al. Validation of flash thermography using computed tomography for characterizing inhomogeneities and defects in CFRP structures , 2014 .