Multi-objective model for simultaneous distribution networks reconfiguration and allocation of D-STATCOM under uncertainties of RESs

This paper proposes an approach for simultaneous placement of distribution static compensator (D-STATCOM) and renewable energy sources (RESs) and distribution system reconfiguration (DSR) based on ...

[1]  R. Piwko,et al.  A mighty wind , 2009, IEEE Power and Energy Magazine.

[2]  Amin Safari,et al.  Optimal setting and placement of FACTS devices using strength Pareto multi-objective evolutionary algorithm , 2017 .

[3]  W. El-Khattam,et al.  Investigating distributed generation systems performance using Monte Carlo simulation , 2006, IEEE Transactions on Power Systems.

[4]  K. Palanikumar,et al.  Optimization of electrical discharge machining characteristics of WC/Co composites using non-dominated sorting genetic algorithm (NSGA-II) , 2008 .

[5]  Devabalaji K.R,et al.  DSTATCOM allocation in the radial distribution networks with different stability indices using bat algorithm , 2017 .

[6]  T. Yuvaraj,et al.  DSTATCOM allocation in distribution networks considering load variations using bat algorithm , 2017 .

[7]  Javier Contreras,et al.  Stochastic Unit Commitment in Isolated Systems With Renewable Penetration Under CVaR Assessment , 2016, IEEE Transactions on Smart Grid.

[8]  Mahmoud-Reza Haghifam,et al.  Risk based multi-objective dynamic expansion planning of sub-transmission network in order to have eco-reliability, environmental friendly network with higher power quality , 2017 .

[9]  Xiangjing Su,et al.  Multi-objective DSTATCOM placement based on sensitivity analysis and genetic algorithm in unbalanced mv distribution networks , 2017, 2017 IEEE Innovative Smart Grid Technologies - Asia (ISGT-Asia).

[10]  Amin Safari,et al.  Optimum Network Reconfiguration to Improve Power Quality and Reliability in Distribution System , 2016 .

[11]  Seyed Abbas Taher,et al.  Optimal location and sizing of DSTATCOM in distribution systems by immune algorithm , 2014 .

[12]  Sajad Najafi Ravadanegh,et al.  Multi-objective planning model for simultaneous reconfiguration of power distribution network and allocation of renewable energy resources and capacitors with considering uncertainties , 2017 .

[13]  Abbas Rabiee,et al.  Energy Hub Management with Intermittent Wind Power , 2014 .

[14]  Amin Safari,et al.  Optimal sizing of combined heat and power generation units using of MPSO in the Besat Industrial Zone , 2016 .

[15]  Om P. Malik,et al.  Risk-based distributed generation placement , 2008 .

[16]  Chandan Kumar Chanda,et al.  Placement of wind and solar based DGs in distribution system for power loss minimization and voltage stability improvement , 2013 .

[17]  Mohammad Moradzadeh,et al.  Probabilistic and Multi-Objective Placement of D-STATCOM in Distribution Systems Considering Load Uncertainty , 2018 .

[18]  M. Geethanjali,et al.  Optimal location and sizing determination of Distributed Generation and DSTATCOM using Particle Swarm Optimization algorithm , 2014 .

[19]  P. Veers,et al.  To Capture the Wind , 2007, IEEE Power and Energy Magazine.

[20]  Arindam Ghosh,et al.  A flexible DSTATCOM operating in voltage or current control mode , 2002 .

[21]  Fabrizio Giulio Luca Pilo,et al.  Optimal sectionalizing switches allocation in distribution networks , 1999 .

[22]  Selvaraj Ganesh,et al.  Meta‐heuristic technique for network reconfiguration in distribution system with photovoltaic and D‐STATCOM , 2018, IET Generation, Transmission & Distribution.

[23]  Saeed Jazebi,et al.  DSTATCOM allocation in distribution networks considering reconfiguration using differential evolution algorithm , 2011 .

[24]  Ashwani Kumar,et al.  Optimal placement of D-STATCOM using sensitivity approaches in mesh distribution system with time variant load models under load growth , 2016, Ain Shams Engineering Journal.