Scaling of NOx emissions from a laboratory-scale mild combustion furnace

A systematic experimental campaign has been carried out to investigate the scaling of NO{sub x} emissions from a moderate or intense low-oxygen dilution (MILD) combustion furnace operating with a parallel jet burner system in which the reactants and the exhaust ports are all mounted on the same wall. Its maximum capacity was 20 kW from the fuel and 3.3 kW from air preheat, with a turndown ratio of 1:3. The burner system was configured to achieve high dilution of the incoming reactants. A comprehensive data set comprising 191 global measurements of temperature and exhaust gas emissions is presented, together with temperature contours on the furnace centerline plane. It was found that, although heat extraction, air preheat, excess air, firing rate, dilution, and fuel type all affect global NO{sub x} emissions, they do not control NO{sub x} scaling. The combined effects of these global parameters can be ultimately characterized by a furnace temperature and a global residence time. A temperature-time scaling approach, previously reported for open jet diffusion flames, proved to be a useful tool for comparison of NO{sub x} emissions from highly diluted furnace environments regardless of the furnace/burner geometries. Regression-based predictions found the characteristic temperature to correlate with 85%more » of the data with an accuracy of only {+-}50%. The leading-order approach also showed that the jet exit Froude number is of limited value for NO{sub x} scaling in the MILD regime. Because of the weak dependence on temperature observed in the data and the moderate magnitude of the measured temperatures, it is deduced that the prompt-NO and/or N{sub 2}O-intermediate pathways are of significance comparable to that of the thermal-NO pathway. The analysis also suggests that NO{sub x} formation is controlled neither by kinetics nor by mixing, and hence the conditions inside this furnace approach or span the range in which Damkoehler numbers are of order unity, Da=O(1). (author)« less

[1]  H. A. Becker,et al.  The Strong-Jet/Weak-Jet Problem and Aerodynamic Modeling of the CGRI Burner , 1998 .

[2]  S. Turns.  Understanding NOx formation in nonpremixed flames: Experiments and modeling , 1995 .

[3]  W. C. Gardiner.  Gas-phase combustion chemistry , 2000 .

[4]  James F. Driscoll,et al.  Nitric oxide levels of turbulent jet diffusion flames: Effects of residence time and damkohler number☆ , 1992 .

[5]  Bassam B. Dally,et al.  Simultaneous imaging of OH, formaldehyde, and temperature of turbulent nonpremixed jet flames in a heated and diluted coflow , 2007 .

[6]  Roman Weber,et al.  On mathematical modelling of flameless combustion , 2007 .

[7]  Robert C. Steele,et al.  NOx and N2O in lean-premixed jet-stirred flames , 1995 .

[8]  S. Turns,et al.  Oxides of nitrogen emissions from turbulent jet flames: Part II—Fuel dilution and partial premixing effects ☆ , 1993 .

[9]  M. Pinar Mengüç,et al.  Thermal Radiation Heat Transfer , 2020 .

[10]  Michael Flamme,et al.  New combustion systems for gas turbines (NGT) , 2004 .

[11]  Mário Costa,et al.  Nitrogen oxides emissions from buoyancy and momentum controlled turbulent methane jet diffusion flames , 2004 .

[12]  Roman Weber,et al.  On emerging furnace design methodology that provides substantial energy savings and drastic reductions in CO2, CO and NOx emissions , 1999 .

[13]  R. Reyment,et al.  Statistics and Data Analysis in Geology. , 1988 .

[14]  M. Nishimura,et al.  Low-NOx combustion under high preheated air temperature condition in an industrial furnace , 1997 .

[15]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[16]  H. A. Becker,et al.  Performance Characteristics of the Novel Low-NOx CGRI Burner For Use with High Air Preheat , 1998 .

[17]  Stephen R. Turns,et al.  Oxides of nitrogen emissions from turbulent jet flames: Part I—Fuel effects and flame radiation , 1991 .

[18]  J. Wunning,et al.  Flameless oxidation to reduce thermal no-formation , 1997 .

[19]  Norbert Peters,et al.  Characteristics of the reaction zone in a combustor operating at mild combustion , 2001 .

[20]  S. Turns.  An Introduction to Combustion: Concepts and Applications , 2000 .

[21]  Pedro J. Coelho,et al.  Numerical simulation of a mild combustion burner , 2001 .

[22]  János M. Beér,et al.  High efficiency electric power generation: The environmental role , 2007 .

[23]  A. Gupta,et al.  High Temperature Air Combustion: From Energy Conservation to Pollution Reduction , 2002 .

[24]  W. Dahm,et al.  Scaling laws for NOx emission performance of burners and furnaces from 30 kW to 12 MW , 1998 .

[25]  Bassam B. Dally,et al.  Effect of fuel mixture on moderate and intense low oxygen dilution combustion , 2004 .

[26]  N. Peters.  Laminar diffusion flamelet models in non-premixed turbulent combustion , 1984 .

[27]  S Pacala,et al.  Stabilization Wedges: Solving the Climate Problem for the Next 50 Years with Current Technologies , 2004, Science.