Polymeric waveguide Fabry Perot resonators

Optical microcavities are used in variety of applications ranging from sensors to lasers and signal routing in high volume communication networks. Achieving a high quality factor (Q) is necessary for achieving the higher sensitivity in sensing applications and for narrow linewidth light emission in most lasing applications. In this work, we propose a new way for achieving a higher quality factor in thin film, Fabry-Perot polymeric optical resonators. We show that lateral photon confinement in a vertical Fabry-Perot microcavities can be achieved by optical writing of a refractive index profile utilizing our UV-sensitive polymer. This method can improve the quality factor by one or more orders of magnitudes. In order to demonstrate this improvement, the device has been fabricated. The fabricated device consists of two dielectric Bragg reflectors with a layer of 100 μm thick polymer layer between them. The polymer is a thiol-ene/methacrylate photopolymer whose optical index can be modified utilizing standard photo-lithography processes. The refractive index of this polymer can be modified utilizing standard photo-lithography processes. The measured finesse of the fabricated device was 692 and the quality factor was 55000. The achieved finesse combined with the flexible polymer layer allows this device to be used as an ultrasound detector in optical micromachined ultrasound transducers (OMUT).

[1]  Matthew O'Donnell,et al.  Ultrasound detection using polymer microring optical resonator , 2004 .

[2]  B. Crowell.  Light and Matter , 2015 .

[3]  E. Costard,et al.  Enhanced Spontaneous Emission by Quantum Boxes in a Monolithic Optical Microcavity , 1998 .

[4]  Larry R. Dalton,et al.  Polymer micro-ring filters and modulators , 2002 .

[5]  T. J. Kippenberg,et al.  Ultra-high-Q toroid microcavity on a chip , 2003, Nature.

[6]  Sheng-Wen Huang,et al.  High-frequency ultrasound sensors using polymer microring resonators , 2007, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[7]  Pochi Yeh,et al.  Photonics: Optical Electronics in Modern Communications (The Oxford Series in Electrical and Computer Engineering) , 1997 .

[8]  Hood,et al.  The atom-cavity microscope: single atoms bound in orbit by single photons , 2000, Science.

[9]  H. Haus,et al.  Wavelength switching and routing using absorption and resonance , 1998, IEEE Photonics Technology Letters.

[10]  James E. Miller,et al.  Monodisperse porphyrin nanospheres synthesized by coordination polymerization , 2008, Nanotechnology.

[11]  Horst Weber,et al.  Optical Resonators: Fundamentals, Advanced Concepts and Applications , 1997 .

[12]  Jacob B Khurgin,et al.  Integrated waveguide-DBR microcavity opto-mechanical system. , 2011, Optics express.

[13]  P. Beard,et al.  Characterization of a polymer film optical fiber hydrophone for use in the range 1 to 20 MHz: A comparison with PVDF needle and membrane hydrophones , 2000, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[15]  H. Tamiaki,et al.  Transmission electron microscopic study on supramolecular nanostructures of bacteriochlorophyll self-aggregates in chlorosomes of green photosynthetic bacteria. , 2006, Journal of bioscience and bioengineering.

[16]  S. Ashkenazi,et al.  Bragg waveguide ultrasound detectors , 2012, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[17]  A. Knoll,et al.  Vertical microcavities with highQand strong lateral mode confinement , 2013 .

[18]  Tao Ling,et al.  Fabrication and characterization of High Q polymer micro-ring resonator and its application as a sensitive ultrasonic detector , 2011, Optics express.

[19]  H. K. Wickramasinghe,et al.  A Fabry-Perot acoustic surface vibration detector - application to acoustic holography , 1973 .

[20]  Douglas A. Keszler,et al.  Spin-coated zinc oxide transparent transistors , 2003 .

[21]  C. Beavers,et al.  Binary ionic porphyrin nanosheets: electronic and light-harvesting properties regulated by crystal structure. , 2012, Nanoscale.

[22]  M. O'Donnell,et al.  High frequency optoacoustic arrays using etalon detection , 2000, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[23]  Scott W. Corzine,et al.  Analytic expressions for the reflection delay, penetration depth, and absorptance of quarter-wave dielectric mirrors , 1992 .

[24]  Oskar Painter,et al.  Momentum space design of high-Q photonic crystal optical cavities. , 2002, Optics express.

[25]  S. Ashkenazi,et al.  Optical micromachined ultrasound transducers (OMUT)-a new approach for high-frequency transducers , 2013, IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control.

[26]  Y. Jiang,et al.  Donor-acceptor biomorphs from the ionic self-assembly of porphyrins. , 2010, Journal of the American Chemical Society.

[27]  Kenneth McEnaney,et al.  Modeling of concentrating solar thermoelectric generators , 2011 .

[28]  F. Krebs,et al.  Low band gap polymers for organic photovoltaics , 2007 .

[29]  M. Notomi,et al.  Waveguides, resonators and their coupled elements in photonic crystal slabs. , 2004, Optics express.

[30]  H. Mabuchi,et al.  High-Q measurements of fused-silica microspheres in the near infrared. , 1998, Optics letters.

[31]  K. Vahala.  Optical microcavities , 2003, Nature.

[32]  Michal Wagner,et al.  Layer-by-Layer Growth of Electrostatically Assembled Multilayer Porphyrin Films , 1996 .

[33]  Robert W. Boyne,et al.  Monolithic integration of optical waveguide and fluidic channel structures in a thiol-ene/methacrylate photopolymer , 2012 .

[34]  S. T. Picraux,et al.  Enhanced thermoelectric figure of merit in SiGe alloy nanowires by boundary and hole-phonon scattering , 2011 .