Finite element method for sheet forming based on an anisotropic strain-rate potential and the convected coordinate system

[1]  R. Hill.  A theory of the yielding and plastic flow of anisotropic metals , 1948, Proceedings of the Royal Society of London. Series A. Mathematical and Physical Sciences.

[2]  R. Hill.  The mathematical theory of plasticity , 1950 .

[3]  L. E. Malvern.  Introduction to the mechanics of a continuous medium , 1969 .

[4]  W. Hosford.  A Generalized Isotropic Yield Criterion , 1972 .

[5]  John L. Bassani,et al.  Yield characterization of metals with transversely isotropic plastic properties , 1977 .

[6]  Manabu Gotoh,et al.  A finite element analysis of rigid-plastic deformation of the flange in a deep-drawing process based on a fourth-degree yield function , 1978 .

[7]  R. Hill.  Theoretical plasticity of textured aggregates , 1979, Mathematical Proceedings of the Cambridge Philosophical Society.

[8]  William F. Hosford,et al.  Upper-bound anisotropic yield locus calculations assuming 〈111〉-pencil glide , 1980 .

[9]  Dong-Yol Yang,et al.  A rigid-plastic finite element formulation considering the effect of geometric change and its application to hydrostatic bulging , 1985 .

[10]  Dong-Yol Yang,et al.  A rigid-plastic finite-element formulation for the analysis of general deformation of planar anisotropic sheet metals and its applications , 1986 .

[11]  John F. Abel,et al.  Convected systems for curved structural elements , 1987 .

[12]  E. Doege,et al.  Influence of Anisotropy in Sheet Metal Forming , 1988 .

[13]  Dong-Yol Yang,et al.  Rigid-plastic finite element analysis of hydrostatic bulging of elliptic diaphragms using Hill's new yield criterion , 1989 .

[14]  Frédéric Barlat,et al.  Plastic behavior and stretchability of sheet metals. Part I: A yield function for orthotropic sheets under plane stress conditions , 1989 .

[15]  R. Hill.  Constitutive modelling of orthotropic plasticity in sheet metals , 1990 .

[16]  F. Barlat,et al.  A six-component yield function for anisotropic materials , 1991 .

[17]  K. Chung,et al.  Finite element simulation of sheet metal forming for planar anisotropic metals , 1992 .

[18]  K. Chung,et al.  A deformation theory of plasticity based on minimum work paths , 1993 .

[19]  Lawrence H.N. Lee,et al.  Postbifurcation behavior of wrinkles in square metal sheets under Yoshida Test , 1993 .

[20]  Dong-Yol Yang,et al.  RIGID-PLASTIC FINITE-ELEMENT ANALYSIS OF SHEET-METAL FORMING PROCESSES USING CONTINUOUS CONTACT TREATMENT AND MEMBRANE ELEMENTS INCORPORATING BENDING EFFECTS , 1994 .