An experimentally validated electromagnetic energy harvester

Abstract A relatively simple method for determining the electromechanical parameters of electromagnetic energy harvesters are presented in this paper. The optimal power generated through a load resistor at both off-resonance and resonance is derived analytically. The experimentally measured performance of a rudimentary electromechanical energy harvester using a rare-earth magnet shows good agreement with the results from the model. The parasitic generator coil resistance can have a profound effect on the overall performance of an electromagnetic generator by essentially acting to degrade the effective coupling coefficient. Data from the setup electromagnetic generator shows normalized power densities of 1.7 μW/[(m/s 2 ) 2  cm 3 ] operating at a resonance frequency of 112.25 Hz. This power density is comparable with other electromagnetic devices of the same volume operating at these frequencies. The power output of the presented electromagnetic generator is comparable to equivalent piezoelectric generators.

[1]  Rajeevan Amirtharajah,et al.  Self-powered signal processing using vibration-based power generation , 1998, IEEE J. Solid State Circuits.

[2]  Alex Elvin,et al.  Feasibility of structural monitoring with vibration powered sensors , 2006 .

[3]  S. Beeby,et al.  Energy harvesting vibration sources for microsystems applications , 2006 .

[4]  Neil M. White,et al.  An electromagnetic, vibration-powered generator for intelligent sensor systems , 2004 .

[5]  Paul K. Wright,et al.  A piezoelectric vibration based generator for wireless electronics , 2004 .

[6]  S. Beeby,et al.  Electromagnetic Energy Harvesting , 2009 .

[7]  N. G. Stephen,et al.  On energy harvesting from ambient vibration , 2006 .

[8]  D. Inman,et al.  A Review of Power Harvesting from Vibration using Piezoelectric Materials , 2004 .

[9]  N. Elvin,et al.  A General Equivalent Circuit Model for Piezoelectric Generators , 2009 .

[10]  Daniel J. Inman,et al.  An experimentally validated bimorph cantilever model for piezoelectric energy harvesting from base excitations , 2009 .

[11]  F. Langford-Smith.  Radio Designer's Handbook , 1997 .

[12]  Henry A. Sodano,et al.  A review of power harvesting using piezoelectric materials (2003–2006) , 2007 .

[13]  Daniel J. Inman,et al.  On the optimal energy harvesting from a vibration source using a PZT stack , 2009 .

[14]  Daniel J. Inman,et al.  Effect of material constants and mechanical damping on piezoelectric power generation , 2009 .

[15]  Daniel J. Inman,et al.  Energy Harvesting Technologies , 2008 .

[16]  H. Sodano,et al.  Optimal parameters and power characteristics of piezoelectric energy harvesters with an RC circuit , 2009 .