Prediction of the height of destressed zone above the mined panel roof in longwall coal mining

Abstract Longwall mining is one of the most widely used underground mining methods most suitable in relatively flat-lying, thick, and uniform coalbeds. Due to extraction of the coal seam, the panel roof strata above the mined zone will be destressed and then the roof loads will be redistributed and transferred to the front abutment and neighboring solid sections with higher load bearing capacity where the adjacent access tunnels and the corresponding barrier pillars are located. The height of destressed zone (HDZ), in this paper is taken as equivalent to the combined height of the caving and fracturing zones above the mined panel roof induced due to longwall mining. The height of destressed zone plays a vital role in accurate determination of the amount of loads being transferred towards front abutment and panel sides. The paper describes the mechanism of development of the height of this zone. Finally, five new simple, yet conclusive, mathematical approaches to estimate the height of destressed zone are presented. The results of the methods proposed are compared with each other and with the comparable methods. The methods proposed are further compared and verified with in-situ measurements reported in the literatures. The comparative results confirm the agreement that exist among the methods and those with the in-situ measurements as well. Finally the methods have shown that, in short term, the height of destressed zone ranges from 6.5 to 24 times the extraction coal seam height; while, in long term, the height of destressed zone ranges from 11.5 to 46.5 times the extraction coal seam height. Therefore, beyond this height the overburden pressure will be transferred towards the front abutment, the adjacent access tunnels, the intervening barrier pillars as well as the panel rib-sides.

[1]  Gangwei Fan,et al.  Aquifer protection during longwall mining of shallow coal seams: A case study in the Shendong Coalfield of China , 2011 .

[2]  V. Palchik,et al.  Formation of fractured zones in overburden due to longwall mining , 2003 .

[3]  Rao Balusu,et al.  Combining modern assessment methods to improve understanding of longwall geomechanics , 1998 .

[4]  Emmanuel M Detournay,et al.  Hydraulic fracturing to induce caving: Fracture model development and comparison to field data , 2001 .

[5]  Raghu N Singh,et al.  Analytic calculations of hydraulic conductivities above longwall coal faces , 1986 .

[6]  Colin J. Booth,et al.  Potentiometric and aquifer property changes above subsiding longwall mine panels, Illinois basin coalfield , 1992 .

[7]  G. S. Esterhuizen,et al.  Numerical Analysis Of The Impact Of Longwall Panel Width On Methane Emissions And Performance Of Gob Gas Ventholes , 1900 .

[8]  P. Hatherly,et al.  MICROSEISMIC MONITORING OF LONGWALL CAVING PROCESSES AT GORDONSTONE MINE, AUSTRALIA , 1998 .

[9]  P. Kenny,et al.  The caving of the waste on longwall faces , 1969 .

[10]  Neil Styler.  Prediction Of Inter-Strata Movements Above Longwall Faces , 1984 .

[11]  G. S. Esterhuizen,et al.  Reservoir simulation-based modeling for characterizing longwall methane emissions and gob gas venthole production , 2007 .

[12]  F. S. Kendorski,et al.  Strata disturbance prediction for mining beneath surface water and waste impoundments : Proc 1st conference on ground control in mining, Morgantown, 27–29 July 1981, P76–89. Publ Morgantown: West Virginia University, 1981 , 1983 .

[13]  Daigoro Hayashi,et al.  Finite element modeling of stress distributions and problems for multi-slice longwall mining in Bangladesh, with special reference to the Barapukuria coal mine , 2009 .

[14]  V. Palchik,et al.  Influence of physical characteristics of weak rock mass on height of caved zone over abandoned subsurface coal mines , 2002 .

[15]  Gerrit V.R. Goodman,et al.  Hydraulic conductivity changes and influencing factors in longwall overburden determined by slug tests in gob gas ventholes , 2009 .

[16]  R. D. Lama,et al.  Subsidence in the near-vicinity of a longwall face , 1973 .

[17]  J. M. Listak,et al.  Design practices for multiple-seam longwall mines , 1993 .

[18]  H. G. Denkhaus,et al.  Critical review of strata movement theories and their application to practical problems , 1964 .

[19]  Xun Luo,et al.  Integrating tools for longwall geomechanics assessment , 2002 .

[20]  U. K. Singh,et al.  Prediction of caving behavior of strata and optimum rating of hydraulic powered support for longwall workings , 2010 .