Event timing and synchronization are two key aspects to improve in the implementation of distributed data acquisition (dDAQ) systems such as the ones used in fusion experiments. It is also of great importance the integration of dDAQ in control and measurement networks. This paper analyzes the applicability of the IEEE1588 and EPICS standards to solve these problems, and presents a hardware module implementation based in both of them that allow adding these functionalities to any DAQ. The IEEE1588 standard facilitates the integration of event timing and synchronization mechanisms in distributed data acquisition systems based on IEEE 803.3 (Ethernet). An optimal implementation of such system requires the use of network interface devices which include specific hardware resources devoted to the IEE1588 functionalities. Unfortunately, this is not the approach followed in most of the large number of applications available nowadays. Therefore, most solutions are based in software and use standard hardware network interfaces. This paper presents the development of a hardware module (GI2E) with IEEE1588 capabilities which includes USB, RS232, RS485 and CAN interfaces. This permits to integrate any DAQ element that uses these interfaces in dDAQ systems in an efficient and simple way. The module has been developed with Motorola's Coldfire MCF5234 processor and National Semiconductors's PHY DP83640T, providing it with the possibility to implement the PTP protocol of IEEE1588 by hardware, and therefore increasing its performance over other implementations based in software. To facilitate the integration of the dDAQ system in control and measurement networks the module includes a basic Input/Output Controller (IOC) functionality of the Experimental Physics and Industrial Control System (EPICS) architecture. The paper discusses the implementation details of this module and presents its applications in advanced dDAQ applications in the fusion community.
[1]
M Ruiz,et al.
Implementation of local area network extension for instrumentation standard trigger capabilities in advanced data acquisition platforms.
,
2008,
The Review of scientific instruments.
[2]
M. R. Kraimer,et al.
Experience with EPICS in a wide variety of applications
,
1997,
Proceedings of the 1997 Particle Accelerator Conference (Cat. No.97CH36167).
[3]
H. S. Osborne,et al.
The international electrotechnical commission
,
1953,
Electrical Engineering.
[4]
Mariano Ruiz,et al.
Distributed real time data processing architecture for the TJ-II data acquisition system
,
2004
.
[5]
J. Vega,et al.
PXI-based architecture for real time data acquisition and distributed dynamical data processing
,
2005,
14th IEEE-NPSS Real Time Conference, 2005..
[6]
D. Bashore,et al.
Conceptual design for the NSTX central instrumentation and control system
,
1997,
17th IEEE/NPSS Symposium Fusion Engineering (Cat. No.97CH36131).
[7]
M. C. Kyum,et al.
The KSTAR integrated control system based on EPICS
,
2006
.
[8]
J. Vega,et al.
PXI-based architecture for real-time data acquisition and distributed dynamic data processing
,
2006,
IEEE Transactions on Nuclear Science.
[9]
P. Chevtsov,et al.
Information-Control Software for Handling Serial Devices in an EPICS Environment
,
2001
.