Model building of thermoelectric generator exposed to dynamic transient sources

This paper presents the modeling of thermal and power generation behavior of a thermoelectric generator (TEG) exposed to transient sources. Most of the previous research concerned the analysis for steady-state behavior which only involves constant temperature value. However, in practice, the temperature of the TEG input fluctuates with time. Therefore this research will look into a focal point on transient heat sources that is being supplied to the hot junction with natural convection cooling process at the cold junction for single and multiple configuration of TEG. The model obtained the data from existing experiments with predicted various conditions of temperature, heat gradient, internal resistance and current attribute of TEG. Transient analysis on single TEG has shown that the value of Seebeck coefficient, thermal conductivity and figure-of-merit vary with the value of cold side temperature. When the ratio between the load and the internal resistance increases, the voltage increases. By considering the multiple TEGs, the matched voltage shows different values when the number of cascaded TEGs is varied. The simulation results have proven that the variation in the number of cascaded TEGs can be used to determine the output power characteristics of a TEG.

[1]  Cheng-Ting Hsu,et al.  An effective Seebeck coefficient obtained by experimental results of a thermoelectric generator module , 2011 .

[2]  Kishore Pochiraju,et al.  Behavior of thermoelectric generators exposed to transient heat sources , 2013 .

[3]  Shiho Kim.  Analysis and modeling of effective temperature differences and electrical parameters of thermoelectric generators , 2013 .

[4]  S. Ben-Yaakov,et al.  Modeling and Analysis of Thermoelectric Modules , 2005, IEEE Transactions on Industry Applications.

[5]  E. Afjei,et al.  Improving the efficiency of thermal power plant using thermoelectric material , 2012, 2012 4th International Conference on Intelligent and Advanced Systems (ICIAS2012).

[6]  J.A. Ortega,et al.  SPICE model of thermoelectric elements including thermal effects , 2000, Proceedings of the 17th IEEE Instrumentation and Measurement Technology Conference [Cat. No. 00CH37066].

[7]  J.A. Chavez,et al.  Lumped and distributed parameter SPICE models of TE devices considering temperature dependent material properties , 2007, 2007 13th International Workshop on Thermal Investigation of ICs and Systems (THERMINIC).

[8]  D. Crane,et al.  An Introduction to System-Level, Steady-State and Transient Modeling and Optimization of High-Power-Density Thermoelectric Generator Devices Made of Segmented Thermoelectric Elements , 2011 .

[9]  José Higino Correia,et al.  Characterization of thermoelectric generators by measuring the load-dependence behavior , 2011 .

[10]  Nesreen Ghaddar,et al.  Development and testing of a domestic woodstove thermoelectric generator with natural convection cooling , 2005 .

[11]  Jium-Ming Lin,et al.  Model Building and Simulation of Thermoelectric Module Using Matlab/Simulink , 2010 .

[12]  José Higino Correia,et al.  Thin Films for Thermoelectric Applications , 2012 .

[13]  S. Grainger,et al.  Thermoelectric power generation: Properties, application and novel TCAD simulation , 2011, Proceedings of the 2011 14th European Conference on Power Electronics and Applications.

[14]  Gaowei Liang,et al.  Analytical model of parallel thermoelectric generator , 2011 .

[15]  Jordi Salazar,et al.  Methodology for extracting thermoelectric module parameters , 2004, IEEE Transactions on Instrumentation and Measurement.