Complementary Switching in Oxide-Based Bipolar Resistive-Switching Random Memory

Resistive-switching random access memory (RRAM) devices utilizing a crossbar architecture represent a promising alternative for Flash replacement in high-density data storage applications. However, RRAM crossbar arrays require the adoption of diodelike select devices with high on-off -current ratio and with sufficient endurance. To avoid the use of select devices, one should develop passive arrays where the nonlinear characteristic of the RRAM device itself provides self-selection during read and write. This paper discusses the complementary switching (CS) in hafnium oxide RRAM, where the logic bit can be encoded in two high-resistance levels, thus being immune from leakage currents and related sneak-through effects in the crossbar array. The CS physical mechanism is described through simulation results by an ion-migration model for bipolar switching. Results from pulsed-regime characterization are shown, demonstrating that CS can be operated at least in the 10-ns time scale. The minimization of the reset current is finally discussed.

[1]  Young-soo Park,et al.  Two Series Oxide Resistors Applicable to High Speed and High Density Nonvolatile Memory , 2007 .

[2]  Hyunsang Hwang,et al.  Diode-less nano-scale ZrOx/HfOx RRAM device with excellent switching uniformity and reliability for high-density cross-point memory applications , 2010, 2010 International Electron Devices Meeting.

[3]  Daniele Ielmini,et al.  Control of filament size and reduction of reset current below 10 μA in NiO resistance switching memories , 2011 .

[4]  R. Waser,et al.  Integrated Complementary Resistive Switches for Passive High-Density Nanocrossbar Arrays , 2011, IEEE Electron Device Letters.

[5]  A. Sawa.  Resistive switching in transition metal oxides , 2008 .

[6]  Rainer Waser,et al.  Complementary resistive switches for passive nanocrossbar memories. , 2010, Nature materials.

[7]  S. Balatti,et al.  Evidence for Voltage-Driven Set/Reset Processes in Bipolar Switching RRAM , 2012, IEEE Transactions on Electron Devices.

[8]  D. Ielmini,et al.  Physical models of size-dependent nanofilament formation and rupture in NiO resistive switching memories , 2011, Nanotechnology.

[9]  D. Gilmer,et al.  Effects of RRAM Stack Configuration on Forming Voltage and Current Overshoot , 2011, 2011 3rd IEEE International Memory Workshop (IMW).

[10]  M. Choe,et al.  Quantized conductive filament formed by limited Cu source in sub-5nm era , 2011, 2011 International Electron Devices Meeting.

[11]  A. S. Grove.  Physics and Technology of Semiconductor Devices , 1967 .

[12]  D. Ielmini,et al.  Complementary switching in metal oxides: Toward diode-less crossbar RRAMs , 2011, 2011 International Electron Devices Meeting.

[13]  R. Dittmann,et al.  Origin of the Ultra‐nonlinear Switching Kinetics in Oxide‐Based Resistive Switches , 2011 .

[14]  Kinam Kim,et al.  A fast, high-endurance and scalable non-volatile memory device made from asymmetric Ta2O(5-x)/TaO(2-x) bilayer structures. , 2011, Nature materials.

[15]  R. Waser.  Redox-based resistive switching memories. , 2012, Journal of nanoscience and nanotechnology.

[16]  I. Baek,et al.  Multi-layer cross-point binary oxide resistive memory (OxRRAM) for post-NAND storage application , 2005, IEEE InternationalElectron Devices Meeting, 2005. IEDM Technical Digest..

[17]  Daniele Ielmini,et al.  Filament diffusion model for simulating reset and retention processes in RRAM , 2011 .

[18]  Yi-Chou Chen,et al.  An access-transistor-free (0T/1R) non-volatile resistance random access memory (RRAM) using a novel threshold switching, self-rectifying chalcogenide device , 2003, IEEE International Electron Devices Meeting 2003.

[19]  S. Balatti,et al.  Resistive Switching by Voltage-Driven Ion Migration in Bipolar RRAM—Part II: Modeling , 2012, IEEE Transactions on Electron Devices.

[20]  Panagiotis Dimitrakis,et al.  Electrical behavior of memory devices based on fluorene-containing organic thin films , 2008 .

[21]  N. Huby,et al.  Low Temperature Rectifying Junctions for Crossbar Non-Volatile Memory Devices , 2009, 2009 IEEE International Memory Workshop.

[22]  U-In Chung,et al.  Vertical cross-point resistance change memory for ultra-high density non-volatile memory applications , 2006, 2009 Symposium on VLSI Technology.

[23]  S. Balatti,et al.  Resistive Switching by Voltage-Driven Ion Migration in Bipolar RRAM—Part I: Experimental Study , 2012, IEEE Transactions on Electron Devices.

[24]  Frederick T. Chen,et al.  Low power and high speed bipolar switching with a thin reactive Ti buffer layer in robust HfO2 based RRAM , 2008, 2008 IEEE International Electron Devices Meeting.

[25]  Z. R. Wang,et al.  A Self-Rectifying $\hbox{HfO}_{x}$ -Based Unipolar RRAM With NiSi Electrode , 2012, IEEE Electron Device Letters.

[26]  Jiale Liang,et al.  Cross-Point Memory Array Without Cell Selectors—Device Characteristics and Data Storage Pattern Dependencies , 2010, IEEE Transactions on Electron Devices.

[27]  D. Ielmini.  Filamentary-switching model in RRAM for time, energy and scaling projections , 2011, 2011 International Electron Devices Meeting.

[28]  K. Tsunoda,et al.  Reduction in the reset current in a resistive random access memory consisting of NiOx brought about by reducing a parasitic capacitance , 2008 .

[29]  I. Yoo,et al.  2-stack 1D-1R Cross-point Structure with Oxide Diodes as Switch Elements for High Density Resistance RAM Applications , 2007, 2007 IEEE International Electron Devices Meeting.

[30]  Panagiotis Dimitrakis,et al.  Electronic memory device based on a single-layer fluorene-containing organic thin film , 2007 .

[31]  D. Ielmini,et al.  Modeling the Universal Set/Reset Characteristics of Bipolar RRAM by Field- and Temperature-Driven Filament Growth , 2011, IEEE Transactions on Electron Devices.

[32]  Yuchao Yang,et al.  Complementary resistive switching in tantalum oxide-based resistive memory devices , 2012, 1204.3515.

[33]  M. Rozenberg,et al.  Mechanism for bipolar resistive switching in transition-metal oxides , 2010, 1001.0703.