Acoustical-Thermal Noise in a Capacitive MEMS Microphone

Since the size of silicon capacitive micro-electro-mechanical system (MEMS) microphones is getting smaller, the mechanical-thermal noise especially acoustical-thermal noise from the MEMS transducer becomes important taking a significant portion of the total noise. Acoustical-thermal noise caused by the flow resistance of microphone components, including the sound port on the package, perforation holes on the backplate, and the vent holes on the diaphragm, was investigated with lumped element models in this paper. The size of the ventilation holes on the backplate and the air-gap distance between the diaphragm and the backplate were designed to minimize the flow resistance. To estimate the acoustical-thermal noise sources, Johnson-Nyquist's relation was used for the flow resistance, and then the signal-to-noise ratio (SNR) was predicted only with acoustical-thermal noise. A capacitive MEMS microphone which has dual backplates to take advantage of the dual transductions has been compared with the single backplate microphone in terms of SNR. Although the advantage of dual transductions leads to SNR increases by $\sim 3$ dB, the prediction shows that the SNR of the double backplate microphones turns out to be merely 7% higher than the single backplate due to the viscous flow resistance and squeeze film damping caused by the additional backplate.

[1]  Wade Conklin,et al.  Leveraging microelectromechanical microphones inherent matching to reduce noise using multiple microphone elements , 2013 .

[2]  Z. Skvor,et al.  On the acoustical resistance due to viscous losses in the air gap of electrotastic transducers , 1969 .

[3]  Wouter Olthuis,et al.  A review of silicon microphones , 1994 .

[4]  Alfons Dehe,et al.  Improved signal-to-noise ratio of silicon microphones by a high-impedance resistor , 2004 .

[5]  Jim Euchner.  Design , 2014, Catalysis from A to Z.

[6]  Ulrich Krumbein,et al.  The Infineon Silicon MEMS Microphone , 2013 .

[7]  S. B. Lee,et al.  An impedance spectroscopic study of MEMS microphones , 2002, Proceedings of IEEE Sensors.

[8]  P. Rombach,et al.  The first low voltage, low noise differential silicon microphone, technology development and measurement results , 2001, Technical Digest. MEMS 2001. 14th IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.01CH37090).

[9]  T. Gabrielson.  Mechanical-thermal noise in micromachined acoustic and vibration sensors , 1993 .

[10]  M. Younis.  MEMS Linear and Nonlinear Statics and Dynamics , 2011 .

[11]  Helmut Seidel,et al.  Influence of a chip scale package on the frequency response of a MEMS microphone , 2010 .

[12]  M. Rossi,et al.  Acoustics and Electroacoustics , 1992 .

[13]  Elmer V Carlson,et al.  Noise in miniature microphones. , 2002, The Journal of the Acoustical Society of America.

[14]  M. Fuldner,et al.  Analytical analysis and finite element simulation of advanced membranes for silicon microphones , 2005, IEEE Sensors Journal.