Analytical Design Method for a Low-Distortion Microwave InGaP/GaAs HBT Amplifier Based on Transient Thermal Behavior in a GaAs Substrate

Based on the transient thermal behavior in a GaAs substrate, the distortion caused by the self-heating effect in an InGaP/GaAs heterojunction bipolar transistor (HBT) has been analytically compensated. The temperature-time variation in a transistor depends on the thermal characteristics of a semiconductor substrate at the base-band range. For a wideband digital modulated signal as input, a multistage thermal resistor-thermal capacitor ladder circuit is used as a model to emulate the thermal characteristics. The distortion analysis is based on Taylor and Volterra series expansion techniques including both electrical and thermal effects. In addition, a compensation condition for the distortion caused by the thermal influence is also successfully derived based on distortion analysis. The validity of the proposed analytical method is shown for an InGaP/GaAs HBT power amplifier operating at 1.95 GHz. The analytical design results are in good agreement with the measured results.

[1]  Ryo Ishikawa,et al.  Analytic parameter determination for thermal memory effect compensation circuit in microwave InGaP/GaAs HBT power amplifiers , 2011, Asia-Pacific Microwave Conference 2011.

[2]  D. D’Amore,et al.  Modeling the thermal response of semiconductor devices through equivalent electrical networks , 2002 .

[3]  Piet Wambacq,et al.  Distortion analysis of analog integrated circuits , 1998 .

[4]  I. Davies,et al.  Novel integral heatsink structures for power MMICs , 1990 .

[5]  K. Honjo,et al.  Thermal behavior depending on emitter finger and substrate configurations in power heterojunction bipolar transistors , 1998 .

[6]  R. Pease,et al.  High-performance heat sinking for VLSI , 1981, IEEE Electron Device Letters.

[7]  V.A. Chiriac,et al.  System-Level Thermal Performance Optimization for Electronic Module Incorporating Dual-Channel Power Stage For Digital Amplifier , 2006, Thermal and Thermomechanical Proceedings 10th Intersociety Conference on Phenomena in Electronics Systems, 2006. ITHERM 2006..

[8]  Frank Benson,et al.  Coaxial Cables as Sources of Intermodulation Interference at Microwave Frequencies , 1978, IEEE Transactions on Electromagnetic Compatibility.

[9]  T. Rahkonen,et al.  Measurement technique for characterizing memory effects in RF power amplifiers , 2000, RAWCON 2000. 2000 IEEE Radio and Wireless Conference (Cat. No.00EX404).

[10]  James S. Wilson,et al.  Transient Adaptive Thermal Simulation of Microwave Integrated Circuits , 1998, Fourteenth Annual IEEE Semiconductor Thermal Measurement and Management Symposium (Cat. No.98CH36195).

[11]  Yukio Takahashi,et al.  Accurate Distortion Prediction for Thermal Memory Effect in Power Amplifier Using Multi-Stage Thermal RC-Ladder Network , 2007, IEICE Trans. Electron..

[12]  W. Bosch,et al.  Measurement and simulation of memory effects in predistortion linearizers , 1989 .

[13]  Yukio Takahashi,et al.  Distortion Compensation for Thermal Memory Effect on InGaP/GaAs HBT Amplifier by Inserting RC-Ladder Circuit in Base Bias Circuit , 2010, IEICE Trans. Electron..