Three-dimensional finite element method for the filling simulation of injection molding
暂无分享,去创建一个
Zhou Huamin | Geng Tie | Li Dequn | Z. Huamin | Geng Tie | Li Dequn | Huamin Zhou
[1] Suhas V. Patankar,et al. A CONTROL VOLUME-BASED FINITE-ELEMENT METHOD FOR SOLVING THE NAVIER-STOKES EQUATIONS USING EQUAL-ORDER VELOCITY-PRESSURE INTERPOLATION , 1984 .
[2] S. F. Shen,et al. A finite-element/finite-difference simulation of the injection-molding filling process , 1980 .
[3] C. D. Han. Injection and compression molding fundamentals, Avraam I. Isayev, Ed., Marcel Dekker, New York, 1987, 703 pp. Price: $99.75 , 1988 .
[4] H. Schlichting. Boundary Layer Theory , 1955 .
[5] C. J. Hwang,et al. A full 3D finite element analysis of the powder injection molding filling process including slip phenomena , 2002 .
[6] Chaim Gutfinger,et al. Flow analysis network (FAN)—A method for solving flow problems in polymer processing , 1974 .
[7] Huamin Zhou,et al. Computer Filling Simulation of Injection Molding Based on 3D Surface Model , 2002 .
[8] W. H. Liu,et al. Numerical simulation and experimental investigation of injection mold filling with melt solidification , 1989 .
[9] C. Prakash,et al. AN IMPROVED CONTROL VOLUME FINITE-ELEMENT METHOD IFOR HEAT AND MASS TRANSFER, AND FOR FLUID FLOW USING EQUAL-ORDER VELOCITY-PRESSURE INTERPOLATION , 1986 .
[10] T. Coupez,et al. Finite element solution of the 3D mold filling problem for viscous incompressible fluid , 1998 .
[11] R. J. Schnipke,et al. An equal-order velocity-pressure formulation that does not exhibit spurious pressure modes , 1986 .