Improvement of bottoming cycle efficiency and heat rejection for HD truck applications by utilization of EGR and CAC heat

Abstract Considering continuously rising fuel prices and the global warming problem it is significantly important to reduce fuel consumption of engines used in various applications. Of specific importance is the HD diesel engine used in large haul trucks because these vehicles have an extensive operating schedule, their engines have a high power output in the range of 200–400 kW and their number is significantly high. Considering current achievements, it appears that HDDI diesel engine bsfc cannot be significantly reduced in the future unless new ideas or techniques are employed. Under this framework the utilization of exhaust heat becomes inevitable because approximately 30–40% of fuel energy is rejected to the environment. A promising technique for the recovery of energy from the exhaust gas is the use of a Rankine bottoming cycle. This technical solution has been examined in the past with very positive indications and a strong potential for significant improvement. However various technical challenges have to be solved among which most important are packaging and rejection of excess heat from the engine cooling system. For this reason in the present work a simulation model which has been developed to describe the operation of a Rankine bottoming cycle is utilized to estimate the potential efficiency gain from its application on a heavy duty truck powered by a diesel engine. Using the simulation special attention is given to the utilization of EGR cooler and CA cooler (Charge Air) heat to increase the Rankine expander power output and thus improve bsfc reduction potential. Furthermore the utilization of both EGR and CAC heat amounts is used to minimize the negative impact of the Rankine cycle on the engine cooling system, the capacity of which is exceeded at high load. The last results to installation difficulties (larger engine radiator, etc.) and in some cases a significant amount of generated power is consumed to drive the cooling fan which obviously has a strong negative impact on the bsfc reduction potential. For this reason several scenarios are proposed and examined in the present work to avoid or minimize this problem. Results are produced for both organic and steam working media that reveal a very good potential for the application of Rankine bottoming cycles in HD engine applications. Furthermore it is revealed that the utilization of both EGR cooler and CA cooler heat beyond its positive effect on bsfc reduction potential is also beneficial for overall system packaging allowing the serious reduction of primary heat exchanger dimensions.

[1]  John A. Derham,et al.  Air Motion in a Four-Stroke Direct Injection Diesel Engine , 1974 .

[2]  M. McLinden,et al.  NIST Standard Reference Database 23: Reference Fluid Thermodynamic and Transport Properties-REFPROP, Version 8.0 , 2007 .

[3]  Richard Edwin Sonntag,et al.  Fundamentals of Thermodynamics , 1998 .

[4]  K. Nishida,et al.  Simplified Three-Dimensional Modeling of Mixture Formation and Combustion in a D.I. Diesel Engine , 1989 .

[5]  J. Ringler,et al.  Rankine Cycle for Waste Heat Recovery of IC Engines , 2009 .

[6]  Francis A. DiBella,et al.  LABORATORY AND ON-HIGHWAY TESTING OF DIESEL ORGANIC RANKINE COMPOUND LONG-HAUL VEHICLE ENGINE , 1983 .

[7]  Dimitrios T. Hountalas,et al.  Use of a Multi-Zone Combustion Model to Interpret the Effect of Injector Nozzle Hole Geometry on HD DI Diesel Engine Performance and Pollutant Emissions , 2005 .

[8]  Christos Katsanos,et al.  Potentiality for Optimizing Operational Performance and Thermal Management of Diesel Truck Engine Rankine Cycle by Recovering Heat in EGR Cooler , 2010 .

[9]  Kuppan Thulukkanam.  Heat Exchanger Design Handbook , 2013 .

[10]  A. Bejan,et al.  Heat transfer handbook , 2003 .

[11]  Yakup İçingür,et al.  Effect of fuel cetane number and injection pressure on a DI Diesel engine performance and emissions , 2003 .

[12]  Simon K. Chen,et al.  A REVIEW OF ENGINE ADVANCED CYCLE AND RANKINE BOTTOMING CYCLE AND THEIR LOSS EVALUATIONS , 1983 .

[13]  Gerhard Regner,et al.  Achieving High Engine Efficiency for Heavy-Duty Diesel Engines by Waste Heat Recovery Using Supercritical Organic-Fluid Rankine Cycle , 2006 .

[14]  M. Kadota,et al.  Advanced Transient Simulation on Hybrid Vehicle Using Rankine Cycle System , 2008 .

[15]  Dimitrios T. Hountalas,et al.  Possibilities to Achieve Future Emission Limits for HD DI Diesel Engines Using Internal Measures , 2005 .

[16]  Gerhard Regner,et al.  Improving Fuel Economy for HD Diesel Engines with WHR Rankine Cycle Driven by EGR Cooler Heat Rejection , 2009 .

[17]  Edward F. Doyle,et al.  Compounding the Truck Diesel Engine with an Organic Rankine-Cycle System , 1976 .

[18]  Dimitrios T. Hountalas,et al.  Potential Benefits in Heavy Duty Diesel Engine Performance and Emissions from the Use of Variable Compression Ratio , 2006 .

[19]  Dimitrios T. Hountalas,et al.  Study of available exhaust gas heat recovery technologies for HD diesel engine applications , 2007 .

[20]  Shigeru Ogino,et al.  Waste Heat Recovery of Passenger Car Using a Combination of Rankine Bottoming Cycle and Evaporative Engine Cooling System , 1993 .

[21]  G P Purohit,et al.  WASTE HEAT RECOVERY IN TRUCK ENGINES , 1978 .

[22]  Gerhard Regner,et al.  Waste Heat Recovery of Heavy-Duty Diesel Engines by Organic Rankine Cycle Part I: Hybrid Energy System of Diesel and Rankine Engines , 2007 .

[23]  Richard Stobart,et al.  Energy Recovery Systems for Engines , 2008 .

[24]  J. Ramos.  Internal combustion engine modeling , 1989 .

[25]  W. J. D. Annand,et al.  Heat Transfer in the Cylinders of Reciprocating Internal Combustion Engines , 1963 .

[26]  John H. Johnson,et al.  Unsteady Vaporization Histories and Trajectories of Fuel Drops Injected into Swirling Air , 1962 .

[27]  G. C. Mavropoulos,et al.  Effect of exhaust gas recirculation (EGR) temperature for various EGR rates on heavy duty DI diesel engine performance and emissions , 2008 .

[28]  Gajendra Singh,et al.  Performance evaluation of a radiator in a diesel engine—a case study , 1999 .

[29]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[30]  Luco R. DiNanno,et al.  INSTALLATION OF A DIESEL-ORGANIC RANKINE COMPOUND ENGINE IN A CLASS 8 TRUCK FOR A SINGLE-VEHICLE TEST , 1979 .

[31]  A. London,et al.  Compact heat exchangers , 1960 .