Multi response optimization of injection moulding process to reduce sink marks and cycle time

[1]  Dilip Kumar Bagal,et al.  Parametric optimization of plastic injection moulding for FMCG polymer moulding (PMMA) using hybrid Taguchi-WASPAS-Ant Lion optimization algorithm , 2021, Materials Today: Proceedings.

[2]  Mauricio Cabrera-Ríos,et al.  A multicriteria simulation optimization method for injection molding , 2011, Proceedings of the 2011 Winter Simulation Conference (WSC).

[3]  J. Kovács,et al.  Test method development for deformation analysis of injection moulded plastic parts , 2011 .

[4]  Alireza Akbarzadeh,et al.  Parameter Study in Plastic Injection Molding Process using Statistical Methods and IWO Algorithm , 2011 .

[5]  L. Hua,et al.  A hybrid of back propagation neural network and genetic algorithm for optimization of injection molding process parameters , 2011 .

[6]  Lin Hua,et al.  Back Propagation neural network modeling for warpage prediction and optimization of plastic products during injection molding , 2011 .

[7]  Babur Ozcelik,et al.  Influence of injection parameters and mold materials on mechanical properties of ABS in plastic injection molding , 2010 .

[8]  D Mathivanan,et al.  Minimization of sink mark defects in injection molding process - Taguchi approach , 2010 .

[9]  A. H. Ahmad,et al.  Optimization of Warpage Defect in Injection Moulding Process Using ABS Material , 2009, 2009 Third Asia International Conference on Modelling & Simulation.

[10]  Kuo-Ming Tsai,et al.  A study of the effects of process parameters for injection molding on surface quality of optical lenses , 2009 .

[11]  Bo Jiang,et al.  Optimal process design of shrinkage and sink marks in injection molding , 2007 .

[12]  Mancang Song,et al.  Research on effects of injection process parameters on the molding process for ultra-thin wall plastic parts , 2007 .

[13]  Changyu Shen,et al.  Investigation of the Effect of Molding Variables on Sink Marks of Plastic Injection Molded Parts Using Taguchi DOE Technique , 2007 .

[14]  Luigi Maria Galantucci,et al.  Evaluation of filling conditions of injection moulding by integrating numerical simulations and experimental tests , 2003 .

[15]  Johann Sienz,et al.  Sustainable injection moulding: The impact of materials selection and gate location on part warpage and injection pressure , 2015 .

[16]  Mehmet Cakmakci,et al.  Improvement of changeover times via Taguchi empowered SMED/case study on injection molding production , 2014 .

[17]  H. Öktem,et al.  Application of Taguchi optimization technique in determining plastic injection molding process parameters for a thin-shell part , 2007 .

[18]  Babur Ozcelik,et al.  Minimization of warpage and sink index in injection-molded thermoplastic parts using Taguchi optimization method , 2006 .