ACCESSIBILITY AND ERGONOMIC ANALYSIS OF ASSEMBLY PRODUCT AND JIG DESIGNS

Abstract In the aircraft industry, the design of floor assembly jigs (FAJs) is an important activity that directly affects productivity. It involves tool frame generation and locator and clamp placement to ensure that the assembly components are held properly with respect to each other to meet the required tolerances. The tool designer also has to analyze the design to ensure that the assembly process does not pose accessibility and ergonomics related problems. The current approach is dependent on the experience of the tool designer and the limited visualization possible on commercial CAD systems. This leads to extensive redesign when accessibility and ergonomic related problems are detected on the physical prototype. In this research, an integrated Virtual Reality-based environment is being developed for the analysis of assembly product and jig designs. CAD models of the assembly product and jig are imported into a Virtual Reality (VR)-based visualization system for accessibility analysis. A motion tracking system is integrated to allow ergonomic posture analysis. The combined VR and motion tracking system allows evaluation of alternate assembly sequences and the jig design. In this paper, the theoretical basis for the analysis environment is presented along with details of the prototype implementation of this system. Relevance to industry Floor assembly jigs are used extensively by the aircraft industry. Improvement of their design process will lead to savings in better design and reduced development time and cost. Better designs will require fewer changes after the jigs have been fabricated. The overall result will be a reduction in product realization time and cost and improved product quality.

[1]  Chong-Won Lee,et al.  A collision detection method for real time assembly simulation , 1995, Proceedings. IEEE International Symposium on Assembly and Task Planning.

[2]  Kevin W. Lyons,et al.  Representations and Methodologies for Assembly Modeling , 1997 .

[3]  S. Keith Hargrove,et al.  A systems approach to fixture planning and design , 1995 .

[4]  T. Armstrong,et al.  A conceptual model for work-related neck and upper-limb musculoskeletal disorders. , 1993, Scandinavian journal of work, environment & health.

[5]  D. W. Mizell.  Virtual reality and augmented reality in aircraft design and manufacturing , 1994, Proceedings of WESCON '94.

[6]  Cherif Ahrikencheikh,et al.  Optimized-Motion Planning: Theory and Implementation , 1994 .

[7]  D. Deitz.  Human-integrated design , 1995 .

[8]  K. Rong,et al.  Computer-Aided Fixture Design , 1999 .

[9]  C. H. Kim,et al.  Acceptable work limits for the upper extremities with the psychophysical approach , 1994 .

[10]  Shimon Y. Nof,et al.  Minimal precedence constraints for integrated assembly and execution planning , 1996, IEEE Trans. Robotics Autom..

[11]  R Wells,et al.  Quantifying exposure in occupational manual tasks with cumulative trauma disorder potential. , 1991, Ergonomics.

[12]  S. R. Ellis.  Nature and origins of virtual environments: a bibliographical essay , 1991 .

[13]  J. P. Hale,et al.  Applied virtual reality in aerospace design , 1994, Proceedings of WESCON '94.

[14]  K. Z. Karam,et al.  Application of virtual reality devices to the quantitative assessment of manual assembly forces in a factory environment , 1995, Proceedings of IECON '95 - 21st Annual Conference on IEEE Industrial Electronics.

[15]  E. C. Barnes,et al.  Industrial environment: its evaluation and control , 1973 .

[16]  Jeffrey E. Fernandez.  Ergonomics in the workplace , 1995 .