Modeling of lead-frame plastic CSPs for accurate prediction of their low-pass filter effects on RFICs

This paper presents a direct extraction method to construct the electrical models of lead-frame plastic CSPs (Chip Scale Packages) for RFICs from the measured S-parameters. To evaluate the package effects on the reciprocal passive components, the insertion loss for an on-chip 50-ohm microstrip line housed in a 32-pin BCC (Bump Chip Carrier) package was calculated based on the established package model. Excellent agreement with measurement has been found up to 15 GHz. When applied to the non-reciprocal active components, the variation of gain for an HBT (Heterojunction Bipolar Transistor) array housed in an 8-pin BCC package has been also predicted up to 22 GHz successfully. Both cases have demonstrated that the package acts as a low-pass filter to cause a sharp cut off for the RFIC components above a certain frequency.

[1]  R. W. Jackson,et al.  A circuit topology for microwave modeling of plastic surface mount packages , 1996 .

[2]  Tzyy-Sheng Horng,et al.  Electrical modeling of RFIC packages up to 12 GHz , 1999, 1999 Proceedings. 49th Electronic Components and Technology Conference (Cat. No.99CH36299).

[3]  P. J. Tasker,et al.  A physical, yet simple, small-signal equivalent circuit for the heterojunction bipolar transistor , 1997 .

[4]  F. Mernyei.  Measurement and field simulation based characterization of plastic IC packages , 1997, Electrical Performance of Electronic Packaging.

[5]  R. W. Jackson,et al.  Microwave-circuit modeling of high lead-count plastic packages , 1997 .

[6]  Tzyy-Sheng Horng,et al.  Electrical performance improvements on RFICs using bump chip carrier packages as compared to standard small outline packages , 2000, 2000 Proceedings. 50th Electronic Components and Technology Conference (Cat. No.00CH37070).

[7]  Tai-Yu Chou,et al.  Capacitance calculation of IC packages using the finite element method and planes of symmetry , 1994, IEEE Trans. Comput. Aided Des. Integr. Circuits Syst..

[8]  Raj Mittra,et al.  An FDTD-Touchstone hybrid technique for equivalent circuit modeling of SOP electronic packages , 1997 .

[9]  F. Ndagijimana,et al.  Frequency limitation on an assembled SO8 package , 1993, Proceedings of IEEE 43rd Electronic Components and Technology Conference (ECTC '93).

[10]  T. Itoh.  Spectral Domain Immitance Approach for Dispersion Characteristics of Generalized Printed Transmission Lines , 1980 .

[11]  Andreas C. Cangellaris,et al.  Frequency-dependent inductance and resistance calculation for three-dimensional structures in high-speed interconnect systems , 1989 .