Micromachined transducers for ultrasound applications

Within the last decade many interesting solutions for micromachined electroacoustic transducers have been presented, most of them microphones for the audio range. So far they could not compete significantly on the market with miniaturized conventional transducer techniques such as electret microphones. One of the main reasons for this was a limited sensitivity due to a high noise level without offering significant cost advantages. Now two facts raised new attention to micromachined transducers: For high-frequency ultrasound imaging the reduction in size of a single transducer element for 1D and even more for 2D arrays is more and more limited by fabrication and cabling technology. On the other hand, new microfabrication technologies have emerged, allowing a highly reproducible fabrication of electrostatically driven membranes with gap heights below 400 nm. One of the most interesting facts is that with a recently developed process step micromechanical membranes can be fabricated within a modified BiCMOS process. This allows the combination of transducer elements with the driving, preamplifying and multiplexing electronics on a single chip, thus reducing parasitic capacities and noise level significantly. This paper first outlines the history of micromachined transducers. Then it describes the internal structure of a micromechanical transducer element and its acoustical properties. The main differences in comparison to piezoelectric bulk transducers are the significantly lower acoustic impedance of the membranes and the nonlinear electromechanical working principle, leading to consequences in array design, which are discussed. Mathematical models and experimental results for transducer bandwidth, membrane deflection and radiation patterns of transducer arrays are presented and compared with the properties of piezoelectric transducer arrays. The influence of the membrane's relative deflection, the poling voltage, the cabling capacity and the preamplifier characteristics upon transmission level and signal-to-noise ratio are discussed. Finally an outlook for potential applications of micromachined transducers, especially in array configurations, is given.

[1]  Wouter Olthuis,et al.  Modelling of silicon condenser microphones , 1994 .

[2]  Wouter Olthuis,et al.  A polymer condenser microphone on silicon with on-chip CMOS amplifier , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[3]  W. Kühnel,et al.  Micromachined subminiature condenser microphones in silicon , 1992 .

[4]  Wouter Olthuis,et al.  A review of silicon microphones , 1994 .

[5]  J. Bergqvist,et al.  Capacitive microphone with a surface micromachined backplate using electroplating technology , 1994 .

[6]  Butrus T. Khuri-Yakub,et al.  Micromachined ultrasonic transducers: 11.4 MHz transmission in air and more , 1996 .

[7]  Richard S. Muller,et al.  Piezoelectric microphone with on-chip CMOS circuits , 1993 .

[8]  J. Bergqvist,et al.  A silicon condenser microphone using bond and etch-back technology , 1994 .

[9]  R. White.  Silicon-based ultrasonic microsensors and micropumps , 1995 .

[10]  Richard M. White,et al.  Piezoelectric cantilever microphone and microspeaker , 1996 .

[11]  C Wykes,et al.  The performance of capacitive ultrasonic transducers using v-grooved backplates , 1991 .

[12]  E. Graf,et al.  Silicon membrane condenser microphone with integrated field-effect transistor , 1993 .

[13]  T. Bourouina,et al.  A new condenser microphone with a p+ silicon membrane , 1992 .

[14]  Jonathan J. Bernstein,et al.  Micromachined ferroelectric transducers for acoustic imaging , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[15]  W. Kühnel,et al.  Silicon condenser microphone with integrated field-effect transistor , 1991 .

[16]  Wouter Olthuis,et al.  Improvement of the performance of microphones with a silicon nitride diaphragm and backplate , 1994 .

[17]  K. Suzuki,et al.  A silicon electrostatic ultrasonic transducer , 1989, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[18]  Oliver Brand,et al.  Ultrasound-transducer using membrane resonators realized with bipolar IC technology , 1994, Proceedings IEEE Micro Electro Mechanical Systems An Investigation of Micro Structures, Sensors, Actuators, Machines and Robotic Systems.

[19]  Christofer Hierold,et al.  Surface micromachined ultrasound transducers in CMOS technology , 1996, 1996 IEEE Ultrasonics Symposium. Proceedings.

[20]  M. Royer,et al.  ZnO on Si integrated acoustic sensor , 1983 .

[21]  Moises Levy,et al.  ADVANCES IN NON-CONTACT AND AIR-COUPLED TRANSDUCERS , 1994 .

[22]  C. Wykes,et al.  Diagnostic measurements in capacitive transducers , 1993 .

[23]  Richard S. Muller,et al.  IC processed piezoelectric microphone , 1991 .

[24]  D. A. Barrow,et al.  Piezoelectric and Capacitative Microactuators and Devices , 1993 .

[25]  B. Khuri-Yakub,et al.  A surface micromachined electrostatic ultrasonic air transducer , 1996, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[26]  V. Mágori,et al.  Ultrasonic Presence Sensors with Wide Range and High Local Resolution , 1987, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[27]  David A. Hutchins,et al.  Field characterization of an air-coupled micromachined ultrasonic capacitance transducer , 1997 .

[28]  D. Schindel,et al.  Capacitance devices for the controlled generation of ultrasonic fields in liquids , 1991, IEEE 1991 Ultrasonics Symposium,.

[29]  D. Schindel,et al.  The design and characterization of micromachined air-coupled capacitance transducers , 1995, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[30]  T. Gabrielson.  Mechanical-thermal noise in micromachined acoustic and vibration sensors , 1993 .

[31]  G. Hess,et al.  Micromachined silicon subminiature microphones with piezoelectric P(VDF/TRFE)-layers and silicon-nitride-membranes , 1994, Proceedings of 8th International Symposium on Electrets (ISE 8).

[32]  B. Hok,et al.  Electrostatically Excited Diaphragm Driven As A Loudspeaker , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.