A Numerical Study of Single Phase Dielectric Fluid Immersion Cooling of Multichip Modules

Immersion, single phase free convection cooling of multichip modules on a printed circuit board in a pool of dielectric fluid was examined numerically, with experimental verification of baseline cases. A multi-chip module with multiple thermal test cells with temperature sensing capability was simulated. The commercially available computational fluid dynamics program from ANSYS, Fluent, was used with the electronics packaging front end, Icepak, employed to create the models and compact conduction modules. Simulations were first performed of an experimental test vehicle which had five 18 mm by 18 mm die, arranged in a cross pattern, equally spaced die, 25 mm between them. Two of the die were aligned vertically with the center die, two aligned horizontally with it. The board was suspended vertically in a large pool of dielectric fluid. Heat was dissipated in the die at a flux of up to 2 W/cm2, based on the die surface area. Simulation results were compared with experimentally measured die temperature values...