FEM Simulation of Generation of Bulk Acoustic Waves and Their Effects in SAW Devices

This paper presents finite element method (FEM) simulation study of the generation of bulk acoustic waves (BAWs) and their effect on the performance of surface acoustic wave (SAW) devices, using COMSOL MultiphysicsTM. A SAW delay line structure using YZ-cut lithium niobate substrate is simulated. The radiation of the bulk waves in all angles into the interior of the substrate is analyzed. The bulk acoustic waves in SAW devices can affect the device response. Since BAW reflects from the bottom surface of the substrate and interferes with the received SAW at the output, bulk radiation needs careful consideration in the design of SAW devices.

[1]  M. Redwood,et al.  Analysis of Generation and Detection of Surface and Bulk Acoustic Waves by Interdigital Transducers , 1977, IEEE Transactions on Sonics and Ultrasonics.

[2]  M. M. Salomaa,et al.  Parasitic BAW excitation in LSAW transducers , 1998, 1998 IEEE Ultrasonics Symposium. Proceedings (Cat. No. 98CH36102).

[3]  D. Malocha,et al.  Bulk wave excitation from finite length SAW transducers including massloading , 1999, 1999 IEEE Ultrasonics Symposium. Proceedings. International Symposium (Cat. No.99CH37027).

[4]  R. Weigel,et al.  Effects of bulk wave radiation on IDT admittance on 42 degrees YX-LiTaO3. , 2001, IEEE transactions on ultrasonics, ferroelectrics, and frequency control.

[5]  Simulation of generation of bulk acoustic waves by interdigital transducers , 2001, 2001 IEEE Ultrasonics Symposium. Proceedings. An International Symposium (Cat. No.01CH37263).

[6]  W. Wlodarski,et al.  A 3-dimensional finite element approach for simulating acoustic wave propagation in layered SAW devices , 2003, IEEE Symposium on Ultrasonics, 2003.

[7]  B. Bazuin,et al.  3D FE simulation of H2 SAW gas sensor , 2005 .

[8]  David Morgan,et al.  Surface Acoustic Wave Filters: With Applications to Electronic Communications and Signal Processing , 2007 .