A Monolithic CMOS-MEMS 3-Axis Accelerometer With a Low-Noise, Low-Power Dual-Chopper Amplifier

This paper reports a monolithically integrated CMOS-MEMS three-axis capacitive accelerometer with a single proof mass. An improved DRIE post-CMOS MEMS process has been developed, which provides robust single-crystal silicon (SCS) structures in all three axes and greatly reduces undercut of comb fingers. The sensing electrodes are also composed of the thick SCS layer, resulting in high resolution and large sensing capacitance. Due to the high wiring flexibility provided by the fabrication process, fully differential capacitive sensing and common-centroid configurations are realized in all three axes. A low-noise, low- power dual-chopper amplifier is designed for each axis, which consumes only 1 mW power. With 44.5 dB on-chip amplification, the measured sensitivities of x-, y-, and z-axis accelerometers are 520 mV/g, 460 mV/g, and 320 mV/g, respectively, which can be tuned by simply changing the amplitude of the modulation signal. Accordingly, the overall noise floors of the x-, y-, and z-axis are 12 mug/radicHz , 14 mug/radicHz, and 110 mug/radicHz, respectively, when tested at around 200 Hz.

[1]  Huikai Xie,et al.  A 1mW Dual-Chopper Amplifier for a 50-/spl mu/g/spl radic/Hz Monolithic CMOS-MEMS Capacitive Accelerometer , 2006, 2006 Symposium on VLSI Circuits, 2006. Digest of Technical Papers..

[2]  Hidekuni Takao,et al.  A CMOS integrated three-axis accelerometer fabricated with commercial submicrometer CMOS technology and bulk-micromachining , 2001 .

[3]  Wolfgang Kuehnel,et al.  Modelling of the mechanical behaviour of a differential capacitor acceleration sensor , 1995 .

[4]  G. Fedder,et al.  A Low-Noise Low-Offset Capacitive Sensing Amplifier for a 50-g = Hz Monolithic CMOS MEMS Accelerometer , 2004 .

[5]  Kukjin Chun,et al.  A high performance mixed micromachined differential resonant accelerometer , 2002, Proceedings of IEEE Sensors.

[6]  Huikai Xie,et al.  Process Development for CMOS-MEMS Sensors With Robust Electrically Isolated Bulk Silicon Microstructures , 2007, Journal of Microelectromechanical Systems.

[7]  Gary K. Fedder,et al.  Design and fabrication of an integrated CMOS-MEMS 3-axis accelerometer , 2003 .

[8]  G.K. Fedder,et al.  A low-noise low-offset capacitive sensing amplifier for a 50-/spl mu/g//spl radic/Hz monolithic CMOS MEMS accelerometer , 2004, IEEE Journal of Solid-State Circuits.

[9]  P. Sharma.  Mechanics of materials. , 2010, Technology and health care : official journal of the European Society for Engineering and Medicine.

[10]  Khalil Najafi,et al.  A high-sensitivity z-axis capacitive silicon microaccelerometer with a torsional suspension , 1998 .

[11]  Bernhard E. Boser,et al.  A three-axis micromachined accelerometer with a CMOS position-sense interface and digital offset-trim electronics , 1999, IEEE J. Solid State Circuits.

[12]  Huikai Xie,et al.  A single-crystal silicon 3-axis CMOS-MEMS accelerometer , 2004, Proceedings of IEEE Sensors, 2004..

[13]  J. Wortman,et al.  Young's Modulus, Shear Modulus, and Poisson's Ratio in Silicon and Germanium , 1965 .

[14]  K. Najafi,et al.  A monolithic three-axis micro-g micromachined silicon capacitive accelerometer , 2005, Journal of Microelectromechanical Systems.