Sphericity measurements by the radial method: I. Mathematical fundamentals

Traditionally, form errors of spherical components have been assessed on the basis of roundness profiles measured in several randomly selected cross-sections. However, such evaluation is superficial, especially if there are significant local irregularities. A new concept was thus developed at the Kielce University of Technology to enable measurement of spherical specimens along some predefined paths so that the surface is densely covered with a grid of points. This approach assumes that measurements can be performed using a typical radial roundness measuring instrument equipped with a special mechanism for controlled positioning of a measured element. This work discusses the assumptions of the new concept and describes a mathematical model of sphericity measurement by the radial method.

[1]  Malgorzata Poniatowska,et al.  Fitting Spatial Models of Geometric Deviations of Free-Form Surfaces Determined in Coordinate Measurements , 2010 .

[2]  T. Kanada Evaluation of spherical form errors : computation of sphericity by means of minimum zone method and some examinations with using simulated data , 1995 .

[3]  Jyunping Huang An exact minimum zone solution for sphericity evaluation , 1999, Comput. Aided Des..

[4]  Ji-Chun Lee,et al.  Analysis of minimum zone sphericity error using minimum potential energy theory , 1999 .

[5]  Stefan Kunis,et al.  Fast spherical Fourier algorithms , 2003 .

[6]  Michael Krystek,et al.  Interferometric determination of the topographies of absolute sphere radii using the sphere interferometer of PTB , 2010 .

[7]  H. S. Halkacı,et al.  Evaluation of form error at semi-spherical tools by use of image processing , 2007 .

[8]  Rajpal S. Sirohi,et al.  Assessment of surface geometry using confocal scanning optical microscope , 1998 .

[9]  M. S. Shunmugam,et al.  Evaluation of sphericity error from form data using computational geometric techniques , 2002 .

[10]  K. Stępień,et al.  Cylindricity measurement by the V-block method – Theoretical and practical problems , 2011 .

[11]  Tohru Kanada Estimation of sphericity by means of statistical processing for roundness of spherical parts , 1997 .

[12]  J. Sładek,et al.  Evaluation of coordinate measurement uncertainty with use of virtual machine model based on Monte Carlo method , 2012 .

[13]  Adam Gąska,et al.  Modeling and identification of errors of coordinate measuring arms with the use of a metrological model , 2013 .

[14]  M. S. Shunmugam,et al.  Evaluation of circularity and sphericity from coordinate measurement data , 2003 .

[15]  Marek Magdziak,et al.  Usability assessment of selected methods of optimization for some measurement task in coordinate measurement technique , 2012 .

[16]  E Gleason,et al.  A spindleless instrument for the roundness measurement of precision spheres , 1998 .

[17]  Stanisław Adamczak,et al.  Problem of Profile Matching in Sphericity Measurements by the Radial Method , 2012 .

[18]  Liang-Chia Chen,et al.  Automatic 3D surface reconstruction and sphericity measurement of micro spherical balls of miniaturized coordinate measuring probes , 2007 .

[19]  Limei Song,et al.  Novel 3D sphericity evaluation based on SFS-NDT , 2005 .

[20]  Zbigniew Humienny,et al.  Animated visualization of the maximum material requirement , 2012 .