Effectiveness of Adaptive Filter Algorithms and Spectral Kurtosis in Bearing Faults Detection in a Gearbox

Bearing faults detection at the earliest stages is vital in avoiding future catastrophic failures. Many traditional techniques have been established and utilized in detecting bearing faults, though, these diagnostic techniques are not always successful when the bearing faults take place in gearboxes where the vibration signal is complex; under such circumstances it may be necessary to separate the bearing signal from the complex signal. The objective of this paper is to assess the effectiveness of an adaptive filter algorithms compared to a Spectral Kurtosis (SK) algorithm in diagnosing a bearing defects in a gearbox. Two adaptive filters have been used for the purpose of bearing signal separation, these algorithms were Least Mean Square (LMS) and Fast Block LMS (FBLMS) algorithms. These algorithms were applied to identify a bearing defects in a gearbox employed for an aircraft control system for which endurance tests were performed. The results show that the LMS algorithm is capable of detecting the bearing fault earlier in comparison to the other algorithms.

[1]  Robert B. Randall,et al.  Detection and diagnosis of incipient bearing failure in helicopter gearboxes , 2004 .

[2]  Zhou Fu-cheng.  Research on online monitoring and diagnosis of bearing fault of wind turbine gearbox based on undecimated wavelet transformation , 2010, 2010 IEEE Youth Conference on Information, Computing and Telecommunications.

[3]  B. Widrow,et al.  Adaptive filtering in the frequency domain , 1978, Proceedings of the IEEE.

[4]  David,et al.  A comparative experimental study on the diagnostic and prognostic capabilities of acoustics emission, vibration and spectrometric oil analysis for spur gears , 2007 .

[5]  David,et al.  A comparative experimental study on the use of acoustic emission and vibration analysis for bearing defect identification and estimation of defect size , 2006 .

[6]  Markus Rupp,et al.  Convergence Issues in the LMS Adaptive Filter , 2009 .

[7]  Hua-Shu Dou,et al.  Vibration-Based Condition Monitoring , 2013 .

[8]  Robert B. Randall,et al.  The enhancement of fault detection and diagnosis in rolling element bearings using minimum entropy deconvolution combined with spectral kurtosis , 2007 .

[9]  E. Ferrara.  Fast implementations of LMS adaptive filters , 1980 .

[10]  Scott C. Douglas,et al.  Introduction to Adaptive Filters , 1999 .

[11]  B. Widrow,et al.  The complex LMS algorithm , 1975, Proceedings of the IEEE.

[12]  P. D. McFadden,et al.  Vibration monitoring of rolling element bearings by the high-frequency resonance technique — a review , 1984 .

[13]  Vijay K. Madisetti,et al.  The Digital Signal Processing Handbook , 1997 .

[14]  Tomasz Barszcz.  Decomposition of Vibration Signals into Deterministic and Nondeterministic Components and its Capabilities of Fault Detection and Identification , 2009, Int. J. Appl. Math. Comput. Sci..

[15]  J. Antoni.  Fast computation of the kurtogram for the detection of transient faults , 2007 .

[16]  Robert B. Randall,et al.  The spectral kurtosis: application to the vibratory surveillance and diagnostics of rotating machines , 2006 .

[17]  P. D. McFadden,et al.  APPLICATION OF SYNCHRONOUS AVERAGING TO VIBRATION MONITORING OF ROLLING ELEMENT BEARINGS , 2000 .

[18]  Li Li,et al.  Blind vibration component separation and nonlinear feature extraction applied to the nonstationary vibration signals for the gearbox multi-fault diagnosis , 2013 .

[19]  B. Widrow,et al.  Adaptive noise cancelling: Principles and applications , 1975 .

[20]  Robert B. Randall,et al.  Rolling element bearing diagnostics—A tutorial , 2011 .