Transient behavior of concentrated solar oxide thermoelectric generator

Abstract Solar thermoelectric generators (STEGs) can directly harness solar energy for power generation. Experimental and numerical studies on the transient response of an oxide thermoelectric generator (TEG) to variation of solar radiation in semi-cloudy weather are carried out. In the first phase, performance of a STEG is investigated under variable solar radiation. Furthermore, effect of a self-adhesive graphite sheet attached to the hot surface of the STEG on enhancement of thermal and electrical performance is studied. In order to evaluate the system performance at high solar concentrations and high operation temperatures, numerical simulation is performed using finite volume method (FVM). I-V-P curves for both STEG systems, with and without the graphite sheet, are obtained. Variation of the hot and cold side temperatures of the TEG and maximum output power variations versus the time are presented and discussed. The results show that, the graphite absorber has a substantial effect on the power generation by the TEG by enhancement of absorbed radiation. This impact is more noticeable at higher solar concentrations and higher temperatures.

[1]  Peng Li,et al.  Design of a Concentration Solar Thermoelectric Generator , 2010 .

[2]  W. Su,et al.  Recent development of n-type perovskite thermoelectrics , 2016 .

[3]  Lasse Rosendahl,et al.  Transient Model of Hybrid Concentrated Photovoltaic with Thermoelectric Generator , 2017 .

[4]  Lasse Rosendahl,et al.  A comparison of micro-structured flat-plate and cross-cut heat sinks for thermoelectric generation application , 2015 .

[5]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[6]  R. Tuley,et al.  ZT Optimization: An Application Focus , 2017, Materials.

[7]  Hosung Lee,et al.  Validation, Optimization and Simulation of a Solar Thermoelectric Generator Model , 2017, Journal of Electronic Materials.

[8]  M. M. Kaila,et al.  Solar thermoelectric generation using bismuth telluride alloys , 1980 .

[9]  Peng Li,et al.  Simulation and Optimization for System Integration of a Solar Thermoelectric Device , 2011 .

[10]  Harish C. Barshilia,et al.  Performance evaluation of a natural convective-cooled concentration solar thermoelectric generator coupled with a spectrally selective high temperature absorber coating , 2016 .

[11]  Anke Weidenkaff,et al.  Thermoelectric Oxide Modules (TOMs) for the Direct Conversion of Simulated Solar Radiation into Electrical Energy , 2010, Materials.

[12]  H. Nowak.  The sky temperature in net radiant heat loss calculations from low-sloped roofs , 1989 .

[13]  J. Brown,et al.  Semiconducting large bandgap oxides as potential thermoelectric materials for high-temperature power generation? , 2014 .

[14]  Maria Telkes,et al.  Solar Thermoelectric Generators , 1954 .

[15]  Lasse Rosendahl,et al.  Experimental and numerical investigation of hybrid concentrated photovoltaic – Thermoelectric module under low solar concentration , 2018, Energy.

[16]  Subramaniam Shanmugam,et al.  Thermodynamic analysis of solar parabolic dish thermoelectric generator , 2010 .

[17]  Aldo Steinfeld,et al.  A Novel 50kW 11,000 suns High-Flux Solar Simulator Based on an Array of Xenon Arc Lamps , 2007 .

[18]  K. Romanjek,et al.  High temperature solar thermoelectric generator – Indoor characterization method and modeling , 2015 .

[19]  Lasse Rosendahl,et al.  Transient behavior of the thermoelectric generators to the load change: An experimental investigation , 2018 .

[20]  Matteo Chiesa,et al.  Modeling and optimization of solar thermoelectric generators for terrestrial applications , 2012 .

[21]  Harish C. Barshilia,et al.  Performance evaluation of a thermally concentrated solar thermo-electric generator without optical concentration , 2016 .

[22]  A. Rezania,et al.  New Configurations of Micro Plate-Fin Heat Sink to Reduce Coolant Pumping Power , 2012, Journal of Electronic Materials.

[23]  Harish C. Barshilia,et al.  Experimental analysis and evaluation of a vacuum enclosed concentrated solar thermoelectric generator coupled with a spectrally selective absorber coating , 2018 .

[24]  Christopher G. Provatidis,et al.  Computational analysis and performance optimization of a solar thermoelectric generator , 2015 .

[25]  Lasse Rosendahl,et al.  Evaluating Thermoelectric Power Generation Device Performance Using a Rectangular Microchannel Heat Sink , 2011 .

[26]  Lasse Rosendahl,et al.  Feasibility and parametric evaluation of hybrid concentrated photovoltaic-thermoelectric system , 2017 .

[27]  Lasse Rosendahl,et al.  Behavior of hybrid concentrated photovoltaic-thermoelectric generator under variable solar radiation , 2018 .

[28]  Hugh W. Coleman,et al.  Experimentation and Uncertainty Analysis for Engineers , 1989 .

[29]  Ivo Alxneit,et al.  Spectral Characterization of PSI’s High-Flux Solar Simulator , 2012 .

[30]  T. Lippert,et al.  Development of thermoelectric oxides for renewable energy conversion technologies , 2008 .

[31]  Chang Chung Yang,et al.  Modeling and simulation for the design of thermal-concentrated solar thermoelectric generator , 2014 .

[32]  Lasse Rosendahl,et al.  Experimental Study on Effect of Operating Conditions on Thermoelectric Power Generation , 2017 .

[33]  Gang Chen,et al.  High-performance flat-panel solar thermoelectric generators with high thermal concentration. , 2011, Nature materials.

[34]  T. Seetawan,et al.  Improvement in thermoelectric properties of CaMnO3 by Bi doping and hot pressing , 2017 .

[35]  James Loomis,et al.  Concentrating solar thermoelectric generators with a peak efficiency of 7.4% , 2016, Nature Energy.

[36]  David Michael Rowe,et al.  A high performance solar powered thermoelectric generator , 1981 .