In-situ analysis of the elastic-plastic characteristics of high strength dual-phase steel

[1]  Y. Korkolis,et al.  Transient Hardening and R-value Behavior in Two-step Tension and Loading Reversal for DP980 Sheet , 2022, IOP Conference Series: Materials Science and Engineering.

[2]  W. Volk,et al.  In-situ Analysis of the Thermoelastic Effect and its Relation to the Onset of Yielding of Low Carbon Steel , 2022, Materials & Design.

[3]  C. Emmelmann,et al.  Evolution of microscopic strains, stresses, and dislocation density during in-situ tensile loading of additively manufactured AlSi10Mg alloy , 2021 .

[4]  R. H. Wagoner,et al.  The nature of yielding and anelasticity in metals , 2021 .

[5]  C. Braham,et al.  Direct determination of phase stress evolution in duplex steel using synchrotron diffraction , 2021 .

[6]  J. Teixeira,et al.  Dislocation densities in a low-carbon steel during martensite transformation determined by in situ high energy X-Ray diffraction , 2021, Materials Science and Engineering: A.

[7]  H. Andrä,et al.  Quantifying internal strains, stresses, and dislocation density in additively manufactured AlSi10Mg during loading-unloading-reloading deformation , 2021 .

[8]  F. Yoshida,et al.  Model for description of nonlinear unloading-reloading stress-strain response with special reference to plastic-strain dependent chord modulus , 2020 .

[9]  S. Münstermann,et al.  A strategy for synthetic microstructure generation and crystal plasticity parameter calibration of fine-grain-structured dual-phase steel , 2020 .

[10]  S. Popović.  Quantitative Phase Analysis by X-ray Diffraction—Doping Methods and Applications , 2020, Crystals.

[11]  W. Volk,et al.  Temperature-based determination of the onset of yielding using a new clip-on device for tensile tests , 2019, Procedia Manufacturing.

[12]  Christoph Hartmann,et al.  Investigation on strain dependent elastic behavior for accurate springback analysis , 2018, Journal of Physics: Conference Series.

[13]  F. Yoshida.  Description of non-linear unloading curve and closure of cyclic stress-strain loop based on Y-U model , 2018, Journal of Physics: Conference Series.

[14]  Chenghao Song,et al.  Stress partitioning among ferrite, martensite and retained austenite of a TRIP-assisted multiphase steel: An in-situ high-energy X-ray diffraction study , 2018 .

[15]  M. Merklein,et al.  A new approach for the determination of the linear elastic modulus from uniaxial tensile tests of sheet metals , 2017 .

[16]  Yannis P. Korkolis,et al.  Dual-phase steel sheets under cyclic tension–compression to large strains: Experiments and crystal plasticity modeling , 2016 .

[17]  J. Sietsma,et al.  Quantification of dislocation structures from anelastic deformation behaviour , 2016 .

[18]  R. H. Wagoner,et al.  The elastic–plastic transition of metals , 2016 .

[19]  N. Schell,et al.  Dislocation density evolution of AA 7020-T6 investigated by in-situ synchrotron diffraction under tensile load , 2015 .

[20]  X. Gómez,et al.  Elastic behaviour characterisation of TRIP 700 steel by means of loading–unloading tests , 2015 .

[21]  L. Nilsson,et al.  A study of the unloading behaviour of dual phase steel , 2014 .

[22]  Myoung-Gyu Lee,et al.  Advanced Issues in springback , 2013 .

[23]  W. Gan,et al.  Rotatable multifunctional load frames for neutron diffractometers at FRM II - Design, specifications and applications , 2013 .

[24]  Aaron P. Stebner,et al.  Young’s modulus evolution and texture-based elastic–inelastic strain partitioning during large uniaxial deformations of monoclinic nickel–titanium , 2013, Acta Materialia.

[25]  S. Han,et al.  Stress–strain relationship between ferrite and martensite in a dual-phase steel studied by in situ neutron diffraction and crystal plasticity theories , 2012 .

[26]  Y. Granbom,et al.  A Dislocation-Based Theory for the Deformation Hardening Behavior of DP Steels: Impact of Martensite Content and Ferrite Grain Size , 2010 .

[27]  Yutaka Kumano,et al.  Tension–compression asymmetry of phosphor bronze for electronic parts and its effect on bending behavior , 2009 .

[28]  Xin Sun,et al.  An in situ high-energy X-ray diffraction study of micromechanical behavior of multiple phases in advanced high-strength steels , 2009 .

[29]  Xin Sun,et al.  Stress and Strain Partitioning of Ferrite and Martensite during Deformation , 2009 .

[30]  Yusheng Zhao,et al.  Microstrain and grain-size analysis from diffraction peak width and graphical derivation of high-pressure thermomechanics , 2008 .

[31]  Amit K. Ghosh,et al.  Elastic and Inelastic Recovery After Plastic Deformation of DQSK Steel Sheet , 2003 .

[32]  P. Lukas,et al.  In situ neutron diffraction study of IF and ultra low carbon steels upon tensile deformation , 2003 .

[33]  Fusahito Yoshida,et al.  Elastic-plastic behavior of steel sheets under in-plane cyclic tension-compression at large strain , 2002 .

[34]  A. Ghosh,et al.  Inelastic effects on springback in metals , 2002 .

[35]  H. Kühn,et al.  Den Elastizitätsmodul sicher bestimmen , 2000 .

[36]  Fabrice Morestin,et al.  On the necessity of taking into account the variation in the Young modulus with plastic strain in elastic-plastic software , 1996 .

[37]  Fabrice Morestin,et al.  Elasto plastic formulation using a kinematic hardening model for springback analysis in sheet metal forming , 1996 .

[38]  Zhonghao Jiang,et al.  Effects of microstructural variables on the deformation behaviour of dual-phase steel , 1995 .

[39]  Robert Hooke,et al.  A description of helioscopes, and some other instruments , 2004 .

[40]  C. Zener.  Elasticity and anelasticity of metals , 1948 .

[41]  J. H. Hollomon,et al.  Problems in Non‐Elastic Deformation of Metals , 1946 .

[42]  Geoffrey Ingram Taylor,et al.  The Plastic Distortion of Metals , 1932 .

[43]  W. Bragg,et al.  The Reflection of X-Rays by Crystals , 1913, Nature.