Catalytic combustion assisted methane steam reforming in a catalytic plate reactor

A theoretical study of methane steam reforming coupled with methane catalytic combustion in a catalytic plate reactor (CPR) based on a two-dimensional model is presented. Plates with coated catalyst layers of order of micrometers at distances of order of millimetres offer a high degree of compactness and minimise heat and mass transport resistances. Choosing similar operating conditions in terms of inlet composition and temperature as in industrial reformer allows a direct comparison of CPRs with the latter. It is shown that short distance between heat source and heat sink increases the efficiency of heat exchange. Transverse temperature gradients do not exceed 0.5 K across the wall and 40 K across the gas-phase, in contrast to 250 K difference in temperature of outside wall and mean gas phase temperature inside the tube usually observed in conventional reformers. The effectiveness factors for the reforming chemical reactions are about one order of magnitude higher than in conventional processes. Minimisation of heat and mass transfer resistances results in reduction of reactor volume and catalyst weight by two orders of magnitude as compared to industrial reformer. Alteration of distance between plates in the range 1-4 mm does not result in significant difference in reactor performance, if made at constant inlet flowrates. However, if such modifications are made at constant inlet velocities, conversion and temperature profiles are considerably affected. Similar effects are observed when catalyst layer thicknesses are increased. (C) 2003 Elsevier Ltd. All rights reserved.

[1]  Krzysztof Gosiewski,et al.  Simulations of non-stationary reactors for the catalytic conversion of methane to synthesis gas , 2001 .

[2]  R. Grasselli,et al.  Catalytic dehydrogenation (DH) of light paraffins combined with selective hydrogen combustion (SHC): I. DH → SHC → DH catalysts in series (co-fed process mode) , 1999 .

[3]  G. Froment,et al.  Methane steam reforming: II. Diffusional limitations and reactor simulation , 1989 .

[4]  C. F. Cullis,et al.  Oxidation of methane over supported precious metal catalysts , 1983 .

[5]  E. A. Polman,et al.  Novel Compact Steam Reformer for Fuel Cells with Heat Generation by Catalytic Combustion Augmented by Induction Heating , 1999 .

[6]  H. J. Veringa,et al.  A catalytic heat-exchanging tubular reactor for combining of high temperature exothermic and endothermic reactions , 2001 .

[7]  Yung-Fang Yu Yao,et al.  Oxidation of Alkanes over Noble Metal Catalysts , 1980 .

[8]  Lanny D. Schmidt,et al.  Millisecond catalytic wall reactors: dehydrogenation of ethane , 2002 .

[9]  Gilbert F. Froment,et al.  Simulation of the catalytic partial oxidation of methane to synthesis gas , 1996 .

[10]  Lanny D. Schmidt,et al.  Oxidative dehydrogenation of ethane at short contact times: species and temperature profiles within and after the catalyst , 2002 .

[11]  J. P. Hook.  Methane-steam reforming , 1980 .

[12]  M. Baerns,et al.  External mass and heat transfer limitations of the partial oxidation of methane over a Pt/MgO catalyst-consequences for adiabatic reactor operation , 1997 .

[13]  Gerhart Eigenberger,et al.  Efficient reactor concepts for coupling of endothermic and exothermic reactions , 2002 .

[14]  Gerhart Eigenberger,et al.  A new reactor concept for endothermic high-temperature reactions , 1999 .

[15]  G. Froment,et al.  Synthesis gas production from natural gas in a fixed bed reactor with reversed flow , 1996 .

[16]  D. Trimm,et al.  Catalytic combustion of methane , 1995 .

[17]  Pio Forzatti,et al.  A comparison of lumped and distributed models of monolith catalytic combustors , 1995 .

[18]  R. Grasselli,et al.  Catalytic dehydrogenation (DH) of light paraffins combined with selective hydrogen combustion (SHC): II. DH+SHC catalysts physically mixed (redox process mode) , 1999 .

[19]  David L. Trimm,et al.  The combustion of methane on platinum—alumina fibre catalysts—I: Kinetics and mechanism , 1980 .

[20]  X. Verykios,et al.  Development of a novel heat-integrated wall reactor for the partial oxidation of methane to synthesis gas , 1998 .

[21]  J. Richardson,et al.  Dynamics of a sodium heat pipe reforming reactor , 1988 .

[22]  G. Bond,et al.  Catalysis, science and technology , 1983 .

[23]  Milorad P. Dudukovic,et al.  Periodic operation of asymmetric bidirectional fixed-bed reactors with temperature limitations , 1998 .

[24]  Toru Numaguchi,et al.  Intrinsic kinetics and design simulation in a complex reaction network; steam-methane reforming , 1988 .

[25]  J. Ross,et al.  Mechanism of the steam reforming of methane over a coprecipitated nickel-alumina catalyst , 1973 .

[26]  David A. Reay.  Catalytic combustion: current status and implications for energy efficiency in the process industries , 1993 .

[27]  E. R. Gerhard,et al.  Kinetics of the Methane-Steam Reaction , 1975 .

[28]  X. Verykios,et al.  Catalytic partial oxidation of methane in a novel heat-integrated wall reactor , 1997 .

[29]  W. Akers,et al.  Kinetics of the methane‐steam reaction , 1955 .

[30]  David L. Trimm,et al.  Heterogeneous reactor modeling for simulation of catalytic oxidation and steam reforming of methane , 2001 .

[31]  Edward L Cussler,et al.  Diffusion: Mass Transfer in Fluid Systems , 1984 .

[32]  A. Gavriilidis,et al.  Modelling of a catalytic plate reactor for dehydrogenation–combustion coupling , 2001 .

[33]  R. E. Hayes,et al.  Introduction to Catalytic Combustion , 1998 .

[34]  T. S. Wittrig,et al.  Bidirectional adiabatic synthesis gas generator , 1990 .

[35]  R. Hughes,et al.  The kinetics of methane steam reforming over a Ni/α-Al2O catalyst , 2001 .

[36]  J. C. De Deken,et al.  Steam Reforming of Natural Gas: Intrinsic Kinetics, Diffusional Influences, and Reactor Design , 1982 .

[37]  C. C. Pantelides,et al.  A modelling and simulation language for combined lumped and distributed parameter systems , 1996 .

[38]  A simplified procedure for the optimal design of autothermal reactors for endothermic high-temperature reactions , 2001 .

[39]  D. Trimm,et al.  Alternative catalyst bed configurations for the autothermic conversion of methane to hydrogen , 1996 .

[40]  B. K. Hodnett.  Heterogeneous Catalytic Oxidation: Fundamental and Technological Aspects of the Selective and Total Oxidation of Organic Compounds , 2000 .

[41]  G. Froment,et al.  Methane steam reforming, methanation and water‐gas shift: I. Intrinsic kinetics , 1989 .

[42]  F. Zaera,et al.  Kinetic study of the catalytic oxidation of alkanes over nickel, palladium, and platinum foils , 1997 .

[43]  Moustafa A. Soliman,et al.  On the non-monotonic behaviour of methane—steam reforming kinetics , 1990 .

[44]  Vasant R. Choudhary,et al.  High-Temperature Catalytic Oxidative Conversion of Propane to Propylene and Ethylene Involving Coupling of Exothermic and Endothermic Reactions , 2000 .

[45]  David W. Agar.  Multifunctional reactors: Old preconceptions and new dimensions , 1999 .