Modelling of airflow through a stack in a timber-drying kiln

Abstract A two-dimensional pore-scale model is used to predict air flow through a wood drying stack for which both the interstitial and the average flow can be considered as two-dimensional. Timber-drying kilns consist of two parts, a centre region and staggered end sections, each with different flow characteristics. In the centre region the flow resembles flow through a duct and empirical models from literature were used for the evaluation of the pressure loss across the timber stack. The staggered ends, resulting from the stacking method, were analyzed by considering them as porous media. A unified modelling theory for the prediction of the pressure drop of crossflow in a prismatic structure was proposed. The model was derived by volumetrically averaging the equations of motion over an arbitrary two-phase system of stationary solids and a traversing fluid. Closure was obtained by using a formerly introduced rectangular representation of the pore space morphology. The model was applied to a typical stack in timber-drying kilns situated in the southern and eastern parts of South Africa. A scale model was built and accurately tested in a wind tunnel. The predicted results compared favourably to the test results.

[1]  Suresh G. Advani,et al.  EXPERIMENTAL INVESTIGATION OF TRANSVERSE FLOW THROUGH ALIGNED CYLINDERS , 1995 .

[2]  Martha Salcudean,et al.  Modelling of airflow in wood kilns , 2001 .

[3]  Jan Adam Kołodziej.  Filtration resistance of a system of parallel cylinders at a transverse creeping flow , 1986 .

[4]  S. Whitaker.  Diffusion and dispersion in porous media , 1967 .

[5]  B. R. Gebart,et al.  Permeability of Unidirectional Reinforcements for RTM , 1992 .

[6]  Jacob H. Masliyah,et al.  Mathematical modelling of flow through consolidated isotropic porous media , 1988 .

[7]  Andreas Acrivos,et al.  Slow flow past periodic arrays of cylinders with application to heat transfer , 1982 .

[8]  D. F. James,et al.  The permeability of fibrous porous media , 1986 .

[9]  I. Catton,et al.  Transport phenomena in heterogeneous media based on volume averaging theory , 2001 .

[10]  P. Carman.  Fluid flow through granular beds , 1997 .

[11]  Stuart W. Churchill,et al.  A general expression for the correlation of rates of transfer and other phenomena , 1972 .

[12]  O. G. Martynenko,et al.  Handbook of hydraulic resistance , 1986 .

[13]  I. Howells,et al.  Drag on fixed beds of fibres in slow flow , 1998, Journal of Fluid Mechanics.

[14]  A. Zukauskas.  Heat Transfer from Tubes in Crossflow , 1972 .

[15]  Zhangjing Chen,et al.  Primary Driving Force in Wood Vacuum Drying , 1997 .

[16]  Gerhardus Petrus Jacobus Diedericks.  Pore-scale modelling of transport phenomena in homogeneous porous media , 1999 .

[17]  S. Haaland.  Simple and Explicit Formulas for the Friction Factor in Turbulent Pipe Flow , 1983 .

[18]  C. G. Carrington,et al.  Air Flow Patterns in Dehumidifier Wood Drying Kilns , 2004 .

[19]  J. Salin.  MODELING OF WOOD DRYING: A BIBLIOGRAPHY , 1991 .

[20]  J. Masliyah,et al.  Flow through isotropic granular porous media , 1991 .