Wake-up radio architecture for home wireless networks

In this paper it is presented and validated by simulation a wake-up radio receiver (WuRx), allowing to both addressing and wake-up a main radio, with best performance but more energy consuming. The main goal is to reduce the total energy consumption of a home multimedia network by switching off the data module of each equipment during the periods when it is not used. The wake-up receiver is designed to be able to detect a wake-up signal which has a frequency signature and so, it is avoided to activate all data interfaces but only the one of interest.

[1]  Mario Konijnenburg,et al.  A 2.4GHz ULP OOK single-chip transceiver for healthcare applications , 2011, 2011 IEEE International Solid-State Circuits Conference.

[2]  Thomas Herndl,et al.  A 2.4µW Wake-up Receiver for wireless sensor nodes with −71dBm sensitivity , 2011, 2011 IEEE International Symposium of Circuits and Systems (ISCAS).

[3]  Xiaoxi Fan,et al.  Zero bias Schottky diodes use in high performance detection circuits , 2011, Proceedings of 2011 International Conference on Electronics and Optoelectronics.

[4]  S. Gambini,et al.  A 52 $\mu$ W Wake-Up Receiver With $-$ 72 dBm Sensitivity Using an Uncertain-IF Architecture , 2009, IEEE Journal of Solid-State Circuits.

[5]  Hyungchul Kim,et al.  CMOS passive wake-up circuit for sensor network applications , 2010 .

[6]  Guillaume Villemaud,et al.  Low Power Front-End Architecture dedicated to the Multistandard Simultaneous Reception , 2010 .

[7]  Emanuel M. Popovici,et al.  Nano-Power Wireless Wake-Up Receiver With Serial Peripheral Interface , 2011, IEEE Journal on Selected Areas in Communications.

[8]  John A. Stankovic,et al.  Radio-Triggered Wake-Up for Wireless Sensor Networks , 2005, Real-Time Systems.

[9]  Leonhard M. Reindl,et al.  Low power wake-up receiver for wireless sensor nodes , 2010, 2010 Sixth International Conference on Intelligent Sensors, Sensor Networks and Information Processing.

[10]  Mario Konijnenburg,et al.  A 2.4 GHz ULP OOK Single-Chip Transceiver for Healthcare Applications , 2011, IEEE Transactions on Biomedical Circuits and Systems.

[11]  Ye Li,et al.  Cross-layer optimization for energy-efficient wireless communications: a survey , 2009 .