Investigation on laser welding of Ti-6Al-4V plates in corner joint

The article deals with laser beam welding of Ti-6Al-4V plates for aerospace applications. A number of trials are conducted to weld 3-mm-thick plates in corner joint configuration; a specific device for clamping and shielding to prevent oxidation is used. Autogenous welding is investigated, the joint being accessed from the outside, as a butt-welded corner joint. Referring to international standards, the results are first discussed in terms of geometry of the welding bead in the cross-section since titanium alloys are reported to be notch sensitive. Moreover, microstructure and microhardness are investigated. An optimum processing condition is suggested in order to perform laser beam welding with minimal undercut and porosity.

[1]  E. Collings,et al.  Materials Properties Handbook: Titanium Alloys , 1994 .

[2]  Giuseppe Casalino,et al.  Investigation on Ti6Al4V laser welding using statistical and Taguchi approaches , 2005 .

[3]  T. Sınmazçelik,et al.  Laser welding of Ti6Al4V titanium alloys , 2009 .

[4]  Mark J. Anderson,et al.  DOE Simplified: Practical Tools for Effective Experimentation , 2000 .

[5]  Thomas W. Eagar,et al.  Welding processes for aeronautics , 2001 .

[6]  Vittorio Alfieri,et al.  Investigation and Optimization of Laser Welding of Ti-6Al-4 V Titanium Alloy Plates , 2013 .

[7]  David Havrilla,et al.  Advanced welding techniques with optimized accessories for high brightness 1 µm lasers , 2013 .

[8]  Antonino Squillace,et al.  Elevation of tribological properties of alloy Ti – 6% Al – 4% V upon formation of a rutile layer on the surface , 2013, Metal Science and Heat Treatment.

[9]  H. J. Rack,et al.  Phase transformations during cooling in α+β titanium alloys , 1998 .

[10]  J. Mazumder,et al.  Laser material processing: Fourth edition , 2010 .

[11]  Deng Ju,et al.  Electron beam welding, laser beam welding and gas tungsten arc welding of titanium sheet , 2000 .

[12]  M. Donachie.  Titanium: A Technical Guide , 1988 .

[13]  Vittorio Alfieri,et al.  Dissimilar autogenous disk-laser welding of Haynes 188 and Inconel 718 superalloys for aerospace applications , 2013 .

[14]  Antonino Squillace,et al.  Effect of welding parameters on morphology and mechanical properties of Ti–6Al–4V laser beam welded butt joints , 2012 .

[15]  George F. Vander Voort,et al.  Metallography and Microstructures of Stainless Steels and Maraging Steels , 2004 .

[16]  Zhang Li,et al.  Laser welding techniques for titanium alloy sheet , 1997 .

[17]  Srećko Švaić,et al.  Numerical analysis and experimental investigation of welding residual stresses and distortions in a T-joint fillet weld , 2014 .