Performance improvement of a drop-on-demand inkjet printhead using an optimization-based feedforward control method

The printing quality delivered by a drop-on-demand (DoD) inkjet printhead is limited due to the residual oscillations in the ink channel. The maximal jetting frequency of a DoD inkjet printhead can be increased by quickly damping the residual oscillations and by bringing in this way the ink channel to rest after jetting the ink drop. This paper proposes an optimization-based method to design the input actuation waveform for the piezo actuator in order to improve the damping of the residual oscillations. A discrete-time transfer function derived from the narrow-gap model is used to predict the response of the ink channel under the application of the piezo input. Simulation and experimental results are presented to show the applicability of the proposed method.

[1]  M. B. Groot Wassink.  Inkjet printhead performance enhancement by feedforward input design based on two-port modeling , 2007 .

[2]  van den Ppj Paul Bosch,et al.  Modeling and control of inkjet printhead , 2009 .

[3]  H. Wijshoff,et al.  The dynamics of the piezo inkjet printhead operation , 2010 .

[4]  Yee Cheong Lam,et al.  Reduction of droplet volume by controlling actuating waveforms in inkjet printing for micro-pattern formation , 2009 .

[5]  Chris Williams,et al.  Ink-jet printers go beyond paper , 2006 .

[6]  Kyung Hyun Ahn,et al.  Evaluation of jet performance in drop-on-demand (DOD) inkjet printing , 2009 .

[7]  Gene H. Golub,et al.  Matrix computations , 1983 .

[8]  Wallace W. Carr,et al.  An experimental study of drop-on-demand drop formation , 2006 .

[9]  Herman Wijshoff,et al.  Structure- and fluid-dynamics in piezo inkjet printheads , 2008 .

[10]  Frank E. Talke,et al.  Experimental and theoretical study of wave propagation phenomena in drop-on-demand ink jet devices , 1984 .

[11]  Boris N. Pshenichnyj.  The Linearization Method for Constrained Optimization , 1994 .

[12]  M. J. D. Powell,et al.  A fast algorithm for nonlinearly constrained optimization calculations , 1978 .

[13]  Willem Martinus Beltman.  Viscothermal wave propagation, including acousto‐elastic interaction , 2004 .

[14]  Jan M. Maciejowski,et al.  Predictive control : with constraints , 2002 .

[15]  J. de Jong.  Air entrapment in piezo inkjet printing , 2007 .

[16]  J. F. Dijksman,et al.  Hydrodynamics of small tubular pumps , 1984, Journal of Fluid Mechanics.

[17]  C. Grigoropoulos,et al.  Damage-free low temperature pulsed laser printing of gold nanoinks on polymers , 2005 .

[18]  Kye-Si Kwon,et al.  A waveform design method for high-speed inkjet printing based on self-sensing measurement , 2007 .

[19]  Kye-Si Kwon,et al.  Waveform Design Methods for Piezo Inkjet Dispensers Based on Measured Meniscus Motion , 2009, Journal of Microelectromechanical Systems.