Experimental study on operation characteristics of a novel refrigeration system using phase change material

Abstract A refrigeration system using phase change material (PCM) with six operating modes is proposed to reduce the cooling energy use of energy-demanding spaces such as data centers and telecommunication base stations. PCM is used to store the cold of outdoor air (OA) and/or that produced by vapor compression refrigeration (VCR) at night, and to release the stored energy for indoor cooling during the daytime. Real-time space cooling and cold charging by VCR can be accomplished simultaneously. Free cooling from OA can provide significant energy saving for space conditioning. A prototype system using a commercially available PCM was developed and tested to investigate the system performance and operation characteristics. The temperatures of air, water and refrigerant were measured along with the refrigerant pressure. The study calculates and analyzes the refrigerating capacity, cooling capacity, cold storage rate, supplied cold, stored cold, and the coefficient of performance (COP) upon the measurements. Experimental results indicate that the proposed refrigeration system can perform the requested tasks in a stable manner. The paper further compares the operating performances with the cold from OA and from VCR. It is found that under the outdoor temperature of 15 °C, OA appears to be more energy-efficient than VCR when the stored cold is less than 5.8 MJ, but it takes more time to charge the cold.

[1]  Ya-Ling He,et al.  Numerical study on performance of molten salt phase change thermal energy storage system with enhanced tubes , 2012 .

[2]  Guoyuan Ma,et al.  Energy-saving analysis of telecommunication base station with thermosyphon heat exchanger , 2013 .

[3]  Quan Zhang,et al.  Experimental study on the thermal characteristics of micro channel separate heat pipe respect to different filling ratio , 2016 .

[4]  Ruzhu Wang,et al.  A review on phase change cold storage in air-conditioning system: Materials and applications , 2013 .

[5]  Quan Zhang,et al.  An advanced control of hybrid cooling technology for telecommunication base stations , 2016 .

[6]  B. Zivkovic,et al.  An analysis of isothermal phase change of phase change material within rectangular and cylindrical containers , 2001 .

[7]  Mats Westermark,et al.  Phase change material cool storage for a Swedish Passive House , 2011 .

[8]  Saman K. Halgamuge,et al.  Potential of air-side economizers for data center cooling: A case study for key Australian cities , 2013 .

[9]  Xiaoqin Sun,et al.  Performance of a free-air cooling system for telecommunications base stations using phase change materials (PCMs): In-situ tests , 2015 .

[10]  Dan Zhou,et al.  Review on thermal energy storage with phase change materials (PCMs) in building applications , 2012 .

[11]  Z. Zhai,et al.  Energy saving potential of a ventilation system with a latent heat thermal energy storage unit under different climatic conditions , 2016 .

[12]  Takuji Nakamura,et al.  Study of a floor supply air conditioning system using granular phase change material to augment building mass thermal storage—Heat response in small scale experiments , 2006 .

[13]  Robert J. Moffat,et al.  Describing the Uncertainties in Experimental Results , 1988 .

[14]  Quan Zhang,et al.  Experimental investigation on the thermal performance of water cooled multi-split heat pipe system (MSHPS) for space cooling in modular data centers , 2016 .

[15]  Luisa F. Cabeza,et al.  PCM thermal energy storage tanks in heat pump system for space cooling , 2014 .

[16]  Xiaoqin Sun,et al.  A study on the use of phase change materials (PCMs) in combination with a natural cold source for space cooling in telecommunications base stations (TBSs) in China , 2014 .

[17]  Yuebin Yu,et al.  Study on thermal performance of micro-channel separate heat pipe for telecommunication stations: experiment and simulation. , 2015 .

[18]  Joseph Virgone,et al.  Numerical modeling and experimental validation of a PCM to air heat exchanger , 2013 .

[19]  Xiaoqin Sun,et al.  Energy and economic analysis of a building enclosure outfitted with a phase change material board (PCMB) , 2014 .

[20]  Xiaoqin Sun,et al.  Parameter design for a phase change material board installed on the inner surface of building exterior envelopes for cooling in China , 2016 .

[21]  Luisa F. Cabeza,et al.  The use of phase change materials in domestic heat pump and air-conditioning systems for short term storage: A review , 2014 .

[22]  Xiaohua Liu,et al.  Energy performance analysis on telecommunication base station , 2011 .

[23]  Marc A. Rosen,et al.  Thermal performance of a multiple PCM thermal storage unit for free cooling , 2013 .

[24]  Pingfang Hu,et al.  Numerical study on ground source heat pump integrated with phase change material cooling storage system in office building , 2015 .

[25]  Nattaporn Chaiyat,et al.  Energy and economic analysis of a building air-conditioner with a phase change material (PCM) , 2015 .

[26]  Kamaruzzaman Sopian,et al.  Review of thermal energy storage for air conditioning systems , 2012 .

[27]  Yi Chen,et al.  Feasibility study of ventilation cooling technology for telecommunication base stations in Guangzhou , 2008, INTELEC 2008 - 2008 IEEE 30th International Telecommunications Energy Conference.

[28]  Motoi Yamaha,et al.  The Evaluation of Peak Shaving by a Thermal Storage System Using Phase-Change Materials in Air Distribution Systems , 2006 .

[29]  R. Velraj,et al.  An experimental investigation on passive cooling system comprising phase change material and two-phase closed thermosyphon for telecom shelters in tropical and desert regions , 2010 .

[30]  Jae-Weon Jeong,et al.  Energy saving potential of various air-side economizers in a modular data center , 2015 .

[31]  Adeel Waqas,et al.  Thermal performance of latent heat storage for free cooling of buildings in a dry and hot climate: A , 2011 .

[32]  Zhihua Zhou,et al.  Phase change materials for solar thermal energy storage in residential buildings in cold climate , 2015 .

[33]  Luisa F. Cabeza,et al.  Materials used as PCM in thermal energy storage in buildings: A review , 2011 .