Frequency fitting algorithm of control signals based on Hermite curves

The paper presents the process and methodology of nomination control signals based on the measurement signals. The process was made to allow for the determination of the replacement of the control signal in order to adjust its frequency to the frequency of operation of the control system. The purpose of the algorithm is to adjust the frequency of the measured signal to the frequency control circuit when the frequency of the signals from the measurements is too low. The algorithm is based on Hermite curves taking into account measurement signal and their first derivative. The paper also presents the verification of the algorithm. It has been tested to angular displacement measuring signals and their velocity in the human lower limb joints in the sagittal plane.

[1]  Phillip J. McKerrow,et al.  Introduction to robotics , 1991 .

[2]  Fujio Yamaguchi,et al.  Curves and Surfaces in Computer Aided Geometric Design , 1988, Springer Berlin Heidelberg.

[3]  Michal Ostaszewski,et al.  Identification of in-line electric actuator , 2013, Proceedings of the 14th International Carpathian Control Conference (ICCC).

[4]  Chun-Shin Lin,et al.  Joint trajectories of mechanical manipulators for Cartesian path approximation , 1983, IEEE Transactions on Systems, Man, and Cybernetics.

[5]  Chang-Soo Han,et al.  Trajectory for robotic manipulators with torque minimization by using hermit interpolation method , 2013, 2013 13th International Conference on Control, Automation and Systems (ICCAS 2013).

[6]  Jorge Angeles,et al.  The synthesis of smooth trajectories for pick-and-place operations , 1988, IEEE Trans. Syst. Man Cybern..

[7]  Conor James Walsh,et al.  Development of a lightweight, underactuated exoskeleton for load-carrying augmentation , 2006, Proceedings 2006 IEEE International Conference on Robotics and Automation, 2006. ICRA 2006..

[8]  John J. Craig Zhu,et al.  Introduction to robotics mechanics and control , 1991 .