In vitro measured strains in the loaded femur: Quantification of experimental error

Abstract The application of strain gauges to bone surfaces has been extensively employed as a method of determining, strain fields in response to implanted devices in orthopaedics. The aim of this study was to determine some of the experimental errors associated with the use of strain gauges in in vitro experimental investigations of the loaded femur. An experimental protocol was devised to obtain strain data at 20 strain gauged locations on the proximal femur. These data were interpolated using a parametric model. The parametric model was then used to estimate the errors associated with mispositioning of the gauges and deviations in their direction of application to the bone. This sensitivity analysis was also supported by a finite element analysis for the purposes of comparison and cross-validation. The results indicated that the nature of the loading normally employed in the literature can contribute to making the readings for some of the gauges (anterior and posterior) unreliable and redundant, even for small positioning errors. The greatest predicted errors for the lateral and medial gauges were due to misalignment of the gauge as opposed to mispositioning. The size of the gauge had a negligible effect on the errors predicted relative to those caused by misalignment.

[1]  Marco Viceconti,et al.  Comparison of uniaxial and triaxial rosette gages for strain measurement in the femur , 1997 .

[2]  E. G. Little,et al.  Strain gauge measurement , 1992 .

[3]  L Cristofolini,et al.  Mechanical validation of whole bone composite femur models. , 1996, Journal of biomechanics.

[4]  L Cristofolini,et al.  Influence of thigh muscles on the axial strains in a proximal femur during early stance in gait. , 1995, Journal of biomechanics.

[5]  P. Kingsley,et al.  A study to determine the angle of anteversion of the neck of the femur. , 1948, The Journal of bone and joint surgery. American volume.

[6]  C. C. Perry.  The resistance strain gage revisited , 1984 .

[7]  E. Little,et al.  Perspectives of strain measurement techniques , 1992 .

[8]  Christopher B. Ruff,et al.  STRUCTURAL CHANGES IN THE LOWER LIMB BONES WITH AGING AT PECOS PUEBLO , 1981 .

[9]  R. Huiskes,et al.  The relationship between stress shielding and bone resorption around total hip stems and the effects of flexible materials. , 1992, Clinical orthopaedics and related research.

[10]  Y. Yoshioka,et al.  The anatomy and functional axes of the femur. , 1987, The Journal of bone and joint surgery. American volume.

[11]  H. F. Brinson,et al.  Resistance-foil strain-gage technology as applied to composite materials , 1984 .

[12]  A Rohlmann,et al.  Finite-element-analysis and experimental investigation in a femur with hip endoprosthesis. , 1983, Journal of biomechanics.

[13]  B P McNamara,et al.  A minimal parametric model of the femur to describe axial elastic strain in response to loads. , 1996, Medical engineering & physics.

[14]  L. Cristofolini,et al.  Evaluation of experimental and finite element models of synthetic and cadaveric femora for pre-clinical design-analysis. , 1994, Clinical materials.

[15]  W. Hayes,et al.  Cross-sectional geometry of Pecos Pueblo femora and tibiae--a biomechanical investigation: I. Method and general patterns of variation. , 1983, American journal of physical anthropology.

[16]  Mensch Js,et al.  Knee morphology as a guide to knee replacement. , 1975 .

[17]  L. Cristofolini,et al.  Effect of bone-prosthesis interface bonding on stress shielding in cementless THA , 1994 .