Effect of Alternative Liquid Fuels on the Exhaust Particle Size Distributions of a Medium-Speed Diesel Engine

We mainly aimed to determine how alternative liquid fuels affect the exhaust particle size distributions (PSD) emitted by a medium-speed diesel engine. The selected alternative fuels included: circulation-origin marine gas oil (MGO), the 26/74 vol. % blend of renewable naphtha and baseline low-sulfur marine light fuel oil (LFO), and kerosene. PSDs were measured by means of an engine exhaust particle sizer from the raw exhaust of a four-cylinder, turbocharged, intercooled engine. During the measurements, the engine was loaded by an alternator, the maximum power output being set at 600 kW(e) at a speed of 1000 rpm. The partial loads of 450, 300, 150 and 60 kW(e) were also used for measurements. At each load, the PSDs had a distinct peak between 20 and 100 nm regardless of fuel. Relative to the other fuels, circulation-origin MGO emitted the lowest particle numbers at several loads despite having the highest viscosity and highest density. Compared to baseline LFO and kerosene, MGO and the blend of renewable naphtha and LFO were more beneficial in terms of total particle number (TPN). Irrespective of the load or fuel, the TPN consisted mainly of particles detected above the 23 nm size category.

[1]  Jorma Keskinen,et al.  Effect of lubricant on the formation of heavy-duty diesel exhaust nanoparticles. , 2005, Environmental science & technology.

[2]  Leonidas Ntziachristos,et al.  Sampling Conditions for the Measurement of Nucleation Mode Particles in the Exhaust of a Diesel Vehicle , 2004 .

[3]  A. De Filippo,et al.  Diesel nucleation mode particles: semivolatile or solid? , 2008, Environmental science & technology.

[4]  H. Kuuluvainen,et al.  Effect of Injection Parameters on Exhaust Gaseous and Nucleation Mode Particle Emissions of a Tier 4i Nonroad Diesel Engine , 2013 .

[5]  Leonidas Ntziachristos,et al.  Particle emissions characterization from a medium-speed marine diesel engine with two fuels at different sampling conditions , 2016 .

[6]  P. Ni,et al.  Effects of cetane number improvers on the performance of diesel engine fuelled with methanol/biodiesel blend , 2014 .

[7]  J. Keskinen,et al.  Effect of fuel injection pressure on a heavy-duty diesel engine nonvolatile particle emission. , 2011, Environmental science & technology.

[8]  Topi Rönkkö,et al.  Dependence between nonvolatile nucleation mode particle and soot number concentrations in an EGR equipped heavy-duty Diesel engine exhaust. , 2010, Environmental science & technology.

[9]  D. Kittelson Engines and nanoparticles: a review , 1998 .

[10]  Erik Fridell,et al.  Characterization of particles from a marine engine operating at low loads , 2015 .

[11]  M. Maricq,et al.  The effects of the catalytic converter and fuel sulfur level on motor vehicle particulate matter emissions: light duty diesel vehicles. , 2002, Environmental science & technology.

[12]  J. Jokiniemi,et al.  Particulate emissions from large-scale medium-speed diesel engines: 1. Particle size distribution , 2011 .

[13]  Leszek Chybowski,et al.  An overview of systems supplying water into the combustion chamber of diesel engines to decrease the amount of nitrogen oxides in exhaust gas , 2015 .

[14]  Athanasios Tsolakis,et al.  Effects on Particle Size Distribution from the Diesel Engine Operating on RME-Biodiesel with EGR , 2006 .

[15]  A. Raj,et al.  Impact of dicyclopentadiene addition to diesel on cetane number, sooting propensity, and soot characteristics , 2018 .

[16]  Juhun Song,et al.  Biodiesel combustion, emissions and emission control , 2007 .

[17]  G. Voth,et al.  The relative roles of acetylene and aromatic precursors during soot particle inception , 2004 .

[18]  Rajesh N. Patel,et al.  Bio fuels for compression ignition engine: A review on engine performance, emission and life cycle analysis , 2016 .

[19]  Chunsheng Zhao,et al.  Mobility particle size spectrometers: harmonization of technical standards and data structure to facilitate high quality long-term observations of atmospheric particle number size distributions , 2010 .

[20]  Liisa Pirjola,et al.  Nucleation mode particles with a nonvolatile core in the exhaust of a heavy duty diesel vehicle. , 2007, Environmental science & technology.

[21]  Zoran Filipi,et al.  Impact of military JP-8 fuel on heavy-duty diesel engine performance and emissions , 2007 .

[22]  Liisa Pirjola,et al.  Effect of dilution conditions and driving parameters on nucleation mode particles in diesel exhaust : Laboratory and on-road study , 2006 .

[23]  J. Moldanová,et al.  Impact of the 0.1% fuel sulfur content limit in SECA on particle and gaseous emissions from marine vessels , 2016 .

[24]  Yang Li,et al.  Improvement of Engine Exhaust Particle Sizer (EEPS) size distribution measurement - II. Engine exhaust particles , 2016 .

[25]  T. Tuch,et al.  Mobility particle size spectrometers: Calibration procedures and measurement uncertainties , 2018 .

[26]  S. Niemi,et al.  Effects of alternative marine diesel fuels on the exhaust particle size distributions of an off-road diesel engine , 2019, Applied Thermal Engineering.

[27]  Zoran Ristovski,et al.  A comparative study of the number and mass of fine particles emitted with diesel fuel and marine gas oil (MGO) , 2012 .

[28]  Konstantinos Boulouchos,et al.  Influence of diesel engine combustion parameters on primary soot particle diameter. , 2005, Environmental science & technology.