Determination of Thermoacoustic Response in a Demonstrator Gas Turbine Engine

This paper describes an analytical and experimental investigation to obtain the thermoacoustic response of a demonstrator gas turbine engine combustor. The combustor acoustic response for two different fuel injector design configurations was measured. It was found that the combustor maximum peak to peak pressure fluctuations were 0.6 psi to 2 psi for configuration A and B, respectively. Based on the measured acoustic response, another experimental investigation was conducted to identify the design features in configuration B that caused the increase in the acoustic response. The data showed that by changing the fuel injector swirler's vane to inner passage discharge area ratio, the engine acoustic response could be lowered to an acceptable level. A simplified analytical model based on the lumped-parameter approach was then developed to investigate the effect of geometrical changes upon the engine response. The analytical model predicted the fuel injector/ swirlers acoustic response as a function of the swirlers inner passage discharge area ratio and frequency. The predictions were consistent with the experimental observations, in particular, it was predicted that as the area ratio was increased, the system reactance was decreased and as a result the system changed from a damping to an amplifying system.

[1]  B. Vonnegut.  A Vortex Whistle , 1954 .

[2]  Nariyoshi Kobayashi,et al.  Combustion Oscillation Analysis of Premixed Flames at Elevated Pressures , 1998 .

[3]  Krishnan Radhakrishnan,et al.  Combustion-acoustic stability analysis for premixed gas turbine combustors , 1995 .

[4]  Vigor Yang,et al.  Liquid rocket engine combustion instability , 1995 .

[5]  Wei Shyy,et al.  Numerical simulation of thermo-acoustic effect on longitudinal combustion instabilities , 1990 .

[6]  Ben Zinn,et al.  Numerical study of the performance of active control systems for combustion instabilities , 1998 .

[7]  Ann P. Dowling,et al.  Active control of reheat buzz , 1987 .

[8]  P. Langhorne,et al.  Reheat buzz: an acoustically coupled combustion instability. Part 2. Theory , 1988, Journal of Fluid Mechanics.

[9]  Daniel E. Paxson,et al.  A Simplified Model for the Investigation of Acoustically Driven Combustion Instabilities , 1998 .

[10]  M. A. Mawid,et al.  A Numerical Study of Active Control of Combustion-Driven Dynamic Instabilities in Gas-Turbine Combustors , 1999 .

[11]  D. Paxson.  Comparison Between Numerically Modeled and Experimentally Measured Wave-Rotor Loss Mechanisms , 1995 .

[12]  Clifford E. Smith,et al.  CFD Modeling of Combustion Instability in Premixed Axisymmetric Combustors , 1997 .

[13]  M. R. Nalim,et al.  A Numerical Investigation of Premixed Combustion in Wave Rotors , 1996 .

[14]  Daniel W. Paxson.  A general numerical model for wave rotor analysis , 1992 .

[15]  C. P. Chen,et al.  Prediction of high frequency combustion instability in liquid propellant rocket engines , 1992 .

[16]  Daniel E. Paxson,et al.  An improved numerical model for wave rotor design and analysis , 1993 .

[17]  Hukam Chand Mongia,et al.  Combustion dynamic modeling for gas turbine engines , 1998 .

[18]  Daniel E. Paxson,et al.  A comparison between numerically modelled and experimentally measured loss mechanisms in wave rotors , 1993 .