Bipolar-compatible epitaxial poly for smart sensors: stress minimization and applications

Abstract This paper presents the optimization of the fabrication process for bipolar-compatible epipoly for micromachining applications. The use of an epitaxial reactor to grow polysilicon enables the growth of monocrystalline silicon (for bipolar electronics) and polysilicon on top of oxkle (for MEMS) in a single deposition step. However, after bipolar processing the early structures showed compressive strain in the epipoly layer, which then required careful MEMS design. The cause of this compressive strain is shown to be the oxidation steps in the bipolar process. The occurrence of this strain can be explained by the presence of oxygen in the epipoly. An alternative processing technique, where the epipoly is doped using implantation and shielded from oxidation by a nitride layer during further bipolar processing, yields epipoly layers without compressive strain. The full thermal budget of the bipolar process is used to diffuse and activate the implanted epipoly dopant. Functional thermal and electrostatic sensor and actuator structures have been fabricated to demonstrate the feasibility of this process

[1]  W. Riethmuller,et al.  Thick Polycristalline Silicon For Surface Micromechanical Applications: Deposition, Structuring And Mechanical Characterization , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[2]  W. Riethmuller,et al.  Surface Micromachined Accelerometer with Increased Working Capacitance and Force Feedback Operation , 1995, ESSDERC '95: Proceedings of the 25th European Solid State Device Research Conference.

[3]  W. Riethmuller,et al.  Novel Process For A Monolithic Integrated Accelerometer , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[4]  Pasqualina M. Sarro,et al.  The development of a low-stress polysilicon process compatible with standard device processing , 1996 .

[5]  Kuniki Ohwada,et al.  Groove depth uniformization in [110] Si anisotropic etching by ultrasonic wave and application to accelerometer fabrication , 1995, Proceedings IEEE Micro Electro Mechanical Systems. 1995.

[6]  A. Evans,et al.  Polysilicon microstructures , 1991, [1991] Proceedings. IEEE Micro Electro Mechanical Systems.

[7]  W. Riethmüller,et al.  Deposition of thick doped polysilicon films with low stress in an epitaxial reactor for surface micromachining applications , 1995 .

[8]  R. Howe,et al.  A passive, in situ micro strain gauge , 1993, [1993] Proceedings IEEE Micro Electro Mechanical Systems.