Numerical Study of Friction Factor and Heat Transfer Characteristics for Single-Phase Turbulent Flow in Tubes with Helical Micro-Fins

The paper presents a numerical study on the heat transfer and pressure drop, related to flow in pipes with helical micro-fins. For all tested geometries, one applied a constant wall heat flux and fully developed 3D turbulent flow conditions. The influence of the angle of micro fins (referred to the tube axis) on thermal-flow characteristics were tested. The value of this angle was varied – with a step of 10 degrees – from 0 to 90 degrees (representing grooves parallel and perpendicular to the axis, respectively). Before numerical investigation, the pipe with helical angle of 30 degree was tested on an experimental stand. The results obtained from experiment and numerical simulations were compared and presented on the charts. As an effect of the numerical simulations, the friction factor f and Nusselt number characteristics was determined for the range of Re=10 ÷ 1.6 × 10. The analysis of the results showed high, irregular influence of the helical angle on thermal characteristics and pressure drops. Additionally, the ratios: f / fplain, Nu/Nuplain and efficiency indexes (Nu/Nuplain)/( f / fplain) as a function of the Reynolds number for every helical angle were shown on the charts.

[1]  Michele Ciofalo,et al.  Numerical prediction of turbulent flow and heat transfer in helically coiled pipes , 2010 .

[2]  Huixiong Li,et al.  Pressure drop, heat transfer and performance of single-phase turbulent flow in spirally corrugated tubes , 2001 .

[3]  L. Chamra,et al.  Single-phase heat transfer in micro-fin tubes , 1997 .

[4]  Smith Eiamsa-ard,et al.  3-D Numerical simulation of swirling flow and convective heat transfer in a circular tube induced by means of loose-fit twisted tapes☆ , 2009 .

[5]  Majed M. Alhazmy,et al.  Experimental study of turbulent single-phase flow and heat transfer inside a micro-finned tube , 2008 .

[6]  T. S. Ravigururajan,et al.  Development and verification of general correlations for pressure drop and heat transfer in single-phase turbulent flow in enhanced tubes , 1996 .

[7]  M. J. Scott,et al.  A Parametric Analysis of the Performance of Internally Finned Tubes for Heat Exchanger Application , 1980 .

[8]  K. S. Lee,et al.  Single-phase heat transfer and flow characteristics of micro-fin tubes , 2005 .

[9]  P. Jasiński.  Numerical optimization of flow-heat ducts with helical micro-fins , using Entropy Generation Minimization ( EGM ) method , 2011 .

[10]  W. Tao,et al.  Prediction of fully developed turbulent heat transfer of internal helically ribbed tubes – An extension of Gnielinski equation , 2012 .

[11]  Paisarn Naphon,et al.  Tube side heat transfer coefficient and friction factor characteristics of horizontal tubes with helical rib , 2006 .

[12]  Prabhata K. Swamee,et al.  Explicit Equations for Pipe-Flow Problems , 1976 .

[13]  C. C. Wang,et al.  Single-phase heat transfer and flow friction correlations for microfin tubes , 1996 .