论文信息 - The analytical model of ball-spinning force for processing an annular groove on the inner wall of a steel tube

The analytical model of ball-spinning force for processing an annular groove on the inner wall of a steel tube

This paper presents a method for machining an annular groove on the inner wall of a steel tube by ball spinning. Based on spatial analytic geometry theory and assumptions about radial helical feed, the process utilizes a simplified expression of boundary curves of radial and tangential contact area between ball and workpiece. Through curve integration, the equations of radial and tangential contact areas for calculating ball-spinning force have been obtained. Based on results from calculation examples, this paper discusses the relationships between spinning depth, ball diameter, spinning feed, and ball-spinning force. The comparison of calculation results between the analytical model and the finite element method has been supplied, and the validity of the model has been certified.

[1] Hua Lin,et al. 3D Finite Element Method Simulation and Process Design for Cold Rolling Ball Groove Section Ring , 2008 .

[2] Yi Xu,et al. Introduction to a new CNC ball-spinning machine , 2005 .

[3] Bijan Mollaei Dariani,et al. An analytical contact model for finite element analysis of tube spinning process , 2008 .

[4] Dongsheng Qian,et al. Grain refinement limit during hot radial ring rolling of as-cast GCr15 steel , 2016 .

[5] Daming Wang,et al. An investigation on roll adjusting radius in three-dimensional rolling process for three-dimensional surface parts , 2015 .

[6] B. Buchmayr,et al. Analytical, numerical and experimental investigations of a ball spinning expansion process , 2015 .

[7] M. I. Rotarescu. A theoretical analysis of tube spinning using balls , 1995 .

[8] Shi-Hong Zhang,et al. Analysis on folding defects of inner grooved copper tubes during ball spin forming , 2007 .

[9] Yanqiu Zhang,et al. Investigation of interface compatibility during ball spinning of composite tube of copper and aluminum , 2017 .

[10] Berend Denkena,et al. Hybrid machining of roller bearing inner rings by hard turning and deep rolling , 2016 .

[11] Huiping Qi. Research Status and Developing Trends on the Rolling Forming Process of Ring Parts , 2014 .

[12] Li Ping,et al. Application of BPANN in spinning deformation of thin-walled tubular parts with longitudinal inner ribs , 2004 .