Experimental investigation of non-uniform heating effect on flow boiling instabilities in a microchannel-based heat sink

Abstract Two-phase flow boiling in microchannels is one of the most promising cooling technologies for coping with high heat fluxes produced by the next generation of central processor units (CPUs). If flow boiling is to be used as a thermal management method for high heat flux electronics it is necessary to understand the behaviour of a non-uniform heat distribution, which is typically the case observed in a real operating CPU. The work presented is an experimental study of two-phase boiling in a multi-channel silicon heat sink with non-uniform heating, using water as the cooling liquid. Thin nickel film sensors, integrated on the back side of the heat sinks were used in order to gain insight related to temperature fluctuations caused by two-phase flow instabilities under non-uniform heating. The effect of various hotspot locations on the temperature profile and pressure drop has been investigated. It was observed that boiling inside microchannels with axially non-uniform heating leads to high temperature non-uniformity in the transverse direction.

[1]  J. Thome,et al.  Effect of Local Hot Spots on the Maximum Dissipation Rates During Flow Boiling in a Microchannel , 2008, IEEE Transactions on Components and Packaging Technologies.

[2]  A. E. Bergles,et al.  On the Nature of Critical Heat Flux in Microchannels , 2003 .

[3]  D. Kenning,et al.  Saturated Flow Boiling of Water in a Narrow Channel: Experimental Investigation of Local Phenomena , 2001 .

[4]  T. Karayiannis,et al.  1-D modelling of pressure fluctuations due to confined bubble growth during flow boiling in a microchannel , 2009 .

[5]  John T. Wen,et al.  Ledinegg instability in microchannels , 2009 .

[6]  1-D Modelling and 3-D Simulation of Confined Bubble Formation and Pressure Fluctuations During Flow Boiling in a Microchannel With a Rectangular Cross-Section of High Aspect Ratio , 2009 .

[7]  Huiying Wu,et al.  Unstable and stable flow boiling in parallel microchannels and in a single microchannel , 2007 .

[8]  Khellil Sefiane,et al.  Prospects of confined flow boiling in thermal management of microsystems , 2002 .

[9]  A. Mosyak,et al.  Periodic boiling in parallel micro-channels at low vapor quality , 2006 .

[10]  Jae-Mo Koo,et al.  Convective boiling in microchannel heat sinks with spatially-varying heat generation , 2002, ITherm 2002. Eighth Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (Cat. No.02CH37258).

[11]  Albert Mosyak,et al.  Explosive boiling of water in parallel micro-channels , 2005 .

[12]  A. Walton,et al.  Two-phase flow instabilities in microchannels , 2008 .

[13]  Thomas W. Kenny,et al.  Experimental study on two-phase heat transfer in microchannel heat sinks with hotspots , 2003, Ninteenth Annual IEEE Semiconductor Thermal Measurement and Management Symposium, 2003..

[14]  I. Mudawar,et al.  Measurement and prediction of pressure drop in two-phase micro-channel heat sinks , 2003 .

[15]  A. Walton,et al.  Two-phase flow instabilities in a silicon microchannels heat sink , 2009 .

[16]  Y. Peles,et al.  Suppression of Boiling Flow Oscillations in Parallel Microchannels by Inlet , 2006 .

[17]  Satish G. Kandlikar,et al.  Stabilization of Flow Boiling in Microchannels Using Pressure Drop Elements and Fabricated Nucleation Sites , 2006 .