No Fault Found events in maintenance engineering Part 2: Root causes, technical developments and future research

This is the second half of a two paper series covering aspects of the no fault found (NFF) phenomenon, which is highly challenging and is becoming even more important due to increasing complexity and criticality of technical systems. Part 1 introduced the fundamental concept of unknown failures from an organizational, behavioral and cultural stand point. It also reported an industrial outlook to the problem, recent procedural standards, whilst discussing the financial implications and safety concerns. In this issue, the authors examine the technical aspects, reviewing the common causes of NFF failures in electronic, software and mechanical systems. This is followed by a survey on technological techniques actively being used to reduce the consequence of such instances. After discussing improvements in testability, the article identifies gaps in literature and points out the core areas that should be focused in the future. Special attention is paid to the recent trends on knowledge sharing and troubleshooting tools; with potential research on technical diagnosis being enumerated.

[1]  Yuan Lu,et al.  Improving Product Quality and Reliability with Customer Experience Data , 2012, Qual. Reliab. Eng. Int..

[2]  Victor A. Skormin,et al.  Data mining technology for failure prognostic of avionics , 2002 .

[3]  Cynthia Furse,et al.  A critical comparison of reflectometry methods for location of wiring faults , 2006 .

[4]  C. Hughes,et al.  A method of combining intermittent arc fault technologies , 2012, 2012 IEEE AUTOTESTCON Proceedings.

[5]  Michael G. Pecht,et al.  No-fault-found and intermittent failures in electronic products , 2008, Microelectron. Reliab..

[6]  Peter Söderholm A system view of the No Fault Found (NFF) phenomenon , 2007, Reliab. Eng. Syst. Saf..

[7]  F S Nowlan,et al.  RELIABILITY-CENTERED MAINTENANCE , 1978 .

[8]  Liu Guanjun,et al.  A stochastic automaton approach to discriminate intermittent from permanent faults , 2014 .

[9]  Russell P. Kraft,et al.  Improvements to X-ray laminography for automated inspection of solder joints , 1998 .

[10]  C. Neubauer,et al.  Intelligent X-ray inspection for quality control of solder joints , 1997 .

[11]  M. Pecht,et al.  Challenges in the Qualification of Electronic Components and Systems , 2013, IEEE Transactions on Device and Materials Reliability.

[12]  Sang-Deuk Park,et al.  Failure analysis of video processor defined as No Fault Found (NFF): Reproduction in system level and advanced analysis technique in IC level , 2009, Microelectron. Reliab..

[13]  Louis Y Ungar Testability design prevents harm , 2010, IEEE Aerospace and Electronic Systems Magazine.

[14]  Jeffrey Alun Jones No Fault Found , 2014 .

[15]  Michael G. Pecht,et al.  The "trouble not identified" phenomenon in automotive electronics , 2002, Microelectron. Reliab..

[16]  C. Furse,et al.  Noise-domain reflectometry for locating wiring faults , 2005, IEEE Transactions on Electromagnetic Compatibility.

[17]  Jeffrey Alun Jones,et al.  Modelling of maintenance, within discrete event simulation , 2002, Annual Reliability and Maintainability Symposium. 2002 Proceedings (Cat. No.02CH37318).

[18]  Eng Wah Lee,et al.  RFID enabled handheld solution for aerospace MRO operations track and trace , 2011, ETFA2011.

[19]  You Chung Chung,et al.  Application of phase detection frequency domain reflectometry for locating faults in an F-18 flight control harness , 2005, IEEE Transactions on Electromagnetic Compatibility.

[20]  Paul Smith,et al.  Intermittent Fault Location on Live Electrical Wiring Systems , 2008 .

[21]  J. Moubray Reliability-Centered Maintenance , 1991 .

[22]  Michael Pecht,et al.  Physics-of-failure assessment of a cruise control module , 1999 .

[23]  William R Simpson,et al.  Predictors of Organizational-Level Testability Attributes , 1987 .

[24]  Daeil Kwon,et al.  Detection of interconnect failure precursors using RF impedance analysis , 2010 .

[25]  A. Atamer Comparison of FMEA and field-experience for a turbofan engine with application to case based reasoning , 2004, 2004 IEEE Aerospace Conference Proceedings (IEEE Cat. No.04TH8720).

[26]  M.G. Pecht,et al.  Prognostics and health management of electronics , 2008, IEEE Transactions on Components and Packaging Technologies.

[27]  Jeff Jones,et al.  Investigation of the occurrence of: no-faults-found in electronic equipment , 2001, IEEE Trans. Reliab..

[28]  David J. Sherwin,et al.  System Reliability Theory—Models and Statistical Methods , 1995 .

[29]  David Lamper,et al.  Automated Fault Isolation of Intermittent Wiring/Conductive Path Systems Inside Weapons Replaceable Assemblies , 2012 .

[30]  P. Lall,et al.  Prognostics Health Monitoring (PHM) for Prior-Damage Assessment in Electronics Equipment under Thermo-Mechanical Loads , 2007, 2007 Proceedings 57th Electronic Components and Technology Conference.

[31]  P. A. Smith,et al.  A practical implementation of BICS for safety-critical applications , 2000, Proceedings 2000 IEEE International Workshop on Defect Based Testing (Cat. No.PR00637).

[32]  Robert M.H. Knotts,et al.  Civil aircraft maintenance and support Fault diagnosis from a business perspective , 1999 .

[33]  Chris Hockley,et al.  The impact of no fault found on through‐life engineering services , 2012 .

[34]  Richard C. Millar,et al.  Application of Non-Parametric Statistical Methods to Reliability Database Analysis , 2007 .

[35]  J. H. Renner Reliability engineering-an integrated approach at Daimler Chrysler , 1999, 1999 IEEE International Integrated Reliability Workshop Final Report (Cat. No. 99TH8460).

[36]  Israel Beniaminy,et al.  Reducing the "No Fault Found" problem: Contributions from expert-system methods , 2002, Proceedings, IEEE Aerospace Conference.

[37]  Michael G. Pecht,et al.  A health indicator method for degradation detection of electronic products , 2012, Microelectron. Reliab..

[38]  D. J. Burns,et al.  A novel power quality monitor for commercial airplanes , 2002, IMTC/2002. Proceedings of the 19th IEEE Instrumentation and Measurement Technology Conference (IEEE Cat. No.00CH37276).

[39]  Rikard Granström,et al.  Condition monitoring of railway wheels and no fault found problems , 2009 .

[40]  Paul Phillips,et al.  A knowledge driven approach to aerospace condition monitoring , 2011, Knowl. Based Syst..

[41]  Michael Pecht,et al.  Environment and Usage Monitoringof Electronic Products for Health Assessment and Product Design , 2007 .

[42]  Michael Osterman,et al.  Tin whisker analysis of Toyota's electronic throttle controls , 2011 .

[43]  Wenhua Chen,et al.  Improved step stress accelerated life testing method for electronic product , 2012, Microelectron. Reliab..

[44]  John W. Sheppard,et al.  Applying testability analysis for integrated diagnostics , 1992, IEEE Design & Test of Computers.

[45]  Paul Phillips,et al.  1st Annual Symposium on Tackling ‘No Fault Found’ in Maintenance Engineering , 2013 .

[46]  M. Pecht,et al.  Prognostics and Health Monitoring of Electronics , 2006, 2007 International Conference on Thermal, Mechanical and Multi-Physics Simulation Experiments in Microelectronics and Micro-Systems. EuroSime 2007.

[47]  B. Steadman,et al.  Intermittent Fault Detection and Isolation System , 2008, 2008 IEEE AUTOTESTCON.

[48]  Michael Osterman,et al.  Prognostics Assessment of Aluminum Support Structure on a Printed Circuit Board , 2006 .

[49]  Ramin Karim,et al.  E‐maintenance and information logistics: aspects of content format , 2009 .

[50]  W. Shawlee,et al.  Aging avionics-what causes it and how to respond , 2001 .

[51]  D. Koltsov,et al.  Failure mechanisms of legacy aircraft wiring and interconnects , 2008, IEEE Transactions on Dielectrics and Electrical Insulation.

[52]  J.K. Line,et al.  Managing and Predicting Intermittent Failures Within Long Life Electronics , 2008, 2008 IEEE Aerospace Conference.

[53]  L. V. Kirkland,et al.  Nano-scaled electrical sensor devices for integrated circuit diagnostics , 2003, 2003 IEEE Aerospace Conference Proceedings (Cat. No.03TH8652).

[54]  E Hicham,et al.  Failure Mode and Effects Analysis (FMEA) , 2007 .

[55]  William B. Rouse,et al.  Review and Evaluation of Empirical Research in Troubleshooting , 1985 .

[56]  I. J. James Learning the lessons from in-service rejection , 1999 .

[57]  Daming Lin,et al.  A review on machinery diagnostics and prognostics implementing condition-based maintenance , 2006 .

[58]  Anthony Narsing,et al.  RFID And Supply Chain Management: An Assessment Of Its Economic, Technical, And Productive Viability In Global Operations , 2011 .

[59]  G. Ramohalli The Honeywell on-board diagnostic and maintenance system for the Boeing 777 , 1992, [1992] Proceedings IEEE/AIAA 11th Digital Avionics Systems Conference.

[60]  Qian Ping,et al.  Improved step stress accelerated life testing method for electronic product , 2012 .

[61]  Uday Kumar,et al.  On aircraft scheduled maintenance program development , 2010 .

[62]  Tadeusz Kaczorek Nonlinear control design , 1997 .

[63]  Ian K. Jennions,et al.  Towards standardisation of no fault found taxonomy , 2012 .

[64]  Paul Weston,et al.  Fault detection and diagnosis for railway track circuits using neuro-fuzzy systems , 2008 .

[65]  D. Lumbard,et al.  Investigating no fault found in the aerospace industry , 2003, Annual Reliability and Maintainability Symposium, 2003..

[66]  R. A. Boenning,et al.  Marginal checking-a technique to detect incipient failures , 1989, Proceedings of the IEEE National Aerospace and Electronics Conference.

[67]  M. Pecht,et al.  REMAINING LIFE ASSESSMENT OF SHUTTLE REMOTE MANIPULATOR SYSTEM END EFFECTOR ELECTRONICS UNIT 1 , 2003 .

[68]  Xavier Maldague,et al.  Theory and Practice of Infrared Technology for Nondestructive Testing , 2001 .

[69]  Nancy G. Leveson,et al.  Role of Software in Spacecraft Accidents , 2004 .

[70]  M. Pecht,et al.  APPLICATIONS OF IN-SITU HEALTH-MONITORING AND PROGNOSTIC SENSORS , 2004 .

[71]  Tongdan Jin,et al.  RELIABILITY DEPLOYMENT IN DISTRIBUTED MANUFACTURING CHAINS VIA CLOSED-LOOP SIX SIGMA METHODOLOGY , 2011 .

[72]  Y.S. Chang,et al.  Development of RFID Enabled Aircraft Maintenance System , 2006, 2006 4th IEEE International Conference on Industrial Informatics.

[73]  R.J. Meseroll,et al.  Data mining navy flight and maintenance data to affect repair , 2007, 2007 IEEE Autotestcon.

[74]  Cecilia Metra,et al.  Clock faults' impact on manufacturing testing and their possible detection through on-line testing , 2002, Proceedings. International Test Conference.

[75]  Jing Qiu,et al.  A novel fault diagnosis approach based on environmental stress level evaluation , 2013 .

[76]  Robert Paasch,et al.  Designing mechanical systems for optimum diagnosability , 2010 .

[77]  Leonardo Mariani,et al.  Dynamic Analysis for Diagnosing Integration Faults , 2011, IEEE Transactions on Software Engineering.

[78]  P.W. Kalgren,et al.  Advanced diagnostic/prognostic reasoning and evidence transformation techniques for improved avionics maintenance , 2004, 2004 IEEE Aerospace Conference Proceedings (IEEE Cat. No.04TH8720).

[79]  Michael G. Pecht,et al.  A prognostics and health management roadmap for information and electronics-rich systems , 2010, Microelectron. Reliab..

[80]  D. Rosenthal,et al.  Predicting and eliminating built-in test false alarms , 1990 .

[81]  Brian Richardson,et al.  Anecdotal experiences on the value of limited environmental testing for the analysis of “No Fault Found” assemblies , 2011, 2011 IEEE AUTOTESTCON.

[82]  Justin Judkins,et al.  Advanced testing and prognostics of ball grid array components with a stand-alone monitor IC , 2010, IEEE Instrumentation & Measurement Magazine.

[83]  Peter Zoeteweij,et al.  A practical evaluation of spectrum-based fault localization , 2009, J. Syst. Softw..

[84]  L.Y. Ungar,et al.  Unraveling the Cannot Duplicate and Retest OK problems by utilizing physics in testing and diagnoses , 2008, 2008 IEEE AUTOTESTCON.

[85]  H. Schneider Failure mode and effect analysis : FMEA from theory to execution , 1996 .

[86]  Patrick D. T. O'Connor,et al.  Testing for Reliability , 2003 .

[87]  K. N. Subramanian,et al.  Environmental concerns and materials issues in manufactured solder joints , 1997, Proceedings of the 1997 IEEE International Symposium on Electronics and the Environment. ISEE-1997.

[88]  Per-Olof Larsson-Kråik Managing avalanches using cost–benefit–risk analysis , 2012 .

[89]  R.R. Harrison,et al.  Low-Power STDR CMOS Sensor for Locating Faults in Aging Aircraft Wiring , 2007, IEEE Sensors Journal.

[90]  M. Vangel System Reliability Theory: Models and Statistical Methods , 1996 .

[91]  Jonathan Swingler The automotive connector: The influence of powering and lubricating a fretting contact interface , 2000 .

[92]  L. Eduardo Izquierdo,et al.  Functional process adjustments to reduce No-Fault-Found product failures in service caused by in-tolerance faults , 2009 .

[93]  A. Saltelli,et al.  Reliability Engineering and System Safety , 2008 .