An Improved Model-Based Maximum Power Point Tracker for Photovoltaic Panels

It is well known that in a photovoltaic (PV) plant, the modules are connected to switch-mode power converters to enhance the power output in every environmental condition. This task is performed by the maximum power point tracker (MPPT), which provides a current or voltage reference to the converter. Traditional perturb and observe or incremental conductance algorithms are not efficient in rapidly changing conditions, whereas a model-based (MB) MPPT offers a better dynamic performance. Because it is relatively easy to obtain an accurate model of a single PV panel, thus predicting the maximum power point voltage for given environmental conditions, MB MPPTs seemed to be attractive for employing in module integrated converters. Conventional MB MPPT algorithms, however, usually require an expensive pyranometer to properly operate. In this paper, starting from a new set of equations modeling a PV module, a novel MB MPPT technique, which does not require the direct measurement of the solar radiation, is proposed and experimentally validated.

[1]  G. Farivar,et al.  A New Approach for Solar Module Temperature Estimation Using the Simple Diode Model , 2011, IEEE Transactions on Energy Conversion.

[2]  L. Cristaldi,et al.  A simplified model of photovoltaic panel , 2012, 2012 IEEE International Instrumentation and Measurement Technology Conference Proceedings.

[3]  L. Cristaldi,et al.  MPPT definition and validation: A new model-based approach , 2012, 2012 IEEE International Instrumentation and Measurement Technology Conference Proceedings.

[4]  E. Skoplaki,et al.  A simple correlation for the operating temperature of photovoltaic modules of arbitrary mounting , 2008 .

[5]  Joe-Air Jiang,et al.  High-accuracy maximum power point estimation for photovoltaic arrays , 2011 .

[6]  Andres Barrado,et al.  Review of the maximum power point tracking algorithms for stand-alone photovoltaic systems , 2006 .

[7]  M. Heck,et al.  Modeling of the nominal operating cell temperature based on outdoor weathering , 2011 .

[8]  Loredana Cristaldi,et al.  A Simple Photovoltaic Panel Model: Characterization Procedure and Evaluation of the Role of Environmental Measurements , 2012, IEEE Transactions on Instrumentation and Measurement.

[9]  Jae Ho Lee,et al.  Advanced Incremental Conductance MPPT Algorithm with a Variable Step Size , 2006, 2006 12th International Power Electronics and Motion Control Conference.

[10]  K. Ebihara,et al.  Estimation of equivalent circuit parameters of PV module and its application to optimal operation of PV system , 2001 .

[11]  E. Matagne,et al.  A photovoltaic cell model based on nominal data only , 2007, 2007 International Conference on Power Engineering, Energy and Electrical Drives.

[12]  Pablo Sanchis,et al.  On the testing, characterization, and evaluation of PV inverters and dynamic MPPT performance under real varying operating conditions , 2007 .

[13]  J. L. Balenzategui,et al.  Estimation of photovoltaic module yearly temperature and performance based on Nominal Operation Cell Temperature calculations , 2004 .

[14]  Quan Li,et al.  A Review of the Single Phase Photovoltaic Module Integrated Converter Topologies With Three Different DC Link Configurations , 2008, IEEE Transactions on Power Electronics.

[15]  João Viana da Fonseca Neto,et al.  Current control loop for tracking of maximum power point supplied for photovoltaic array , 2003, IEEE Transactions on Instrumentation and Measurement.

[16]  D.A. Adkins.  Novel method and system for monitoring CPV cell and module temperature , 2010, 2010 35th IEEE Photovoltaic Specialists Conference.

[17]  M. Vitelli,et al.  Optimization of perturb and observe maximum power point tracking method , 2005, IEEE Transactions on Power Electronics.

[18]  Antonio Luque,et al.  Handbook of Photovoltaic Science and Engineering: Luque/Handbook of Photovoltaic Science and Engineering , 2010 .

[19]  Marcantonio Catelani,et al.  FMECA technique on photovoltaic module , 2011, 2011 IEEE International Instrumentation and Measurement Technology Conference.

[20]  Geoffrey R. Walker,et al.  Evaluating MPPT Converter Topologies Using a Matlab PV Model , 2000 .

[21]  Marko Topič,et al.  Outdoor testing of PV module temperature and performance under different mounting and operational conditions , 2011 .

[22]  M. E. Ropp,et al.  Comparative study of maximum power point tracking algorithms , 2003 .

[23]  Xiaolei Wang,et al.  A New Method of MPPT Control Based on the Model of Photovoltaic Array , 2011, 2011 Asia-Pacific Power and Energy Engineering Conference.

[24]  P.L. Chapman,et al.  Comparison of Photovoltaic Array Maximum Power Point Tracking Techniques , 2007, IEEE Transactions on Energy Conversion.

[25]  Marcelo Gradella Villalva,et al.  Comprehensive Approach to Modeling and Simulation of Photovoltaic Arrays , 2009, IEEE Transactions on Power Electronics.

[26]  Jun Li,et al.  A High-Efficiency PV Module-Integrated DC/DC Converter for PV Energy Harvest in FREEDM Systems , 2011, IEEE Transactions on Power Electronics.

[27]  Weidong Xiao,et al.  A novel modeling method for photovoltaic cells , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[28]  G.M. Tina,et al.  Electrical and thermal model for PV module temperature evaluation , 2008, MELECON 2008 - The 14th IEEE Mediterranean Electrotechnical Conference.

[29]  Vijay Devabhaktuni,et al.  Improved photovoltaic MPPT algorithm adapted for unstable atmospheric conditions and partial shading , 2009, 2009 International Conference on Clean Electrical Power.