Extending the Power Capability With Dynamic Performance of a Power-Hardware-in-the-Loop Application—Power Grid Emulator Using “Inverter Cumulation”

The increasing use of complex grid-connected technological components in safety-critical applications like public transportation or distributed power systems requires a precise evaluation of the reliability and robustness of these pieces of equipment during their development. Direct on-field tests of high-power systems are generally not possible. A conventional method of getting around this problem consists in using software-based simulation to analyze the behavior of the electric equipment under test (EUT) under normal and transient operation conditions of the grid. However, signal-level simulation is not able to perfectly reproduce every detail of a physical phenomenon. This publication describes a cost-effective realization of a power-hardware-in-the-loop (PHiL) grid emulation system combining two inverters with different electrical characteristics (type of semiconductor, switching frequency, dc link, etc.). The proposed grid emulator is a controllable power source not only capable of emulating low-frequency (50 Hz) transient faults as voltage sags but also high-order harmonic components usually present in the voltage waveforms of the utility grid (e.g., noise). A downscaled 5-kVA laboratory prototype has been implemented and the experimental results shown in this paper demonstrate the emulator's ability to combine high power with high dynamics.

[1]  Thomas G. Habetler,et al.  Design and implementation of an inverter output LC filter used for dv/dt reduction , 2002 .

[2]  R.W. De Doncker,et al.  Control of a medium-voltage test generator , 2008, 2008 IEEE Power Electronics Specialists Conference.

[3]  Poh Chiang Loh,et al.  A comparative analysis of multiloop voltage regulation strategies for single and three-phase UPS systems , 2003 .

[4]  Juan Dixon,et al.  A fault protection scheme for series active power filters , 1996 .

[5]  Frede Blaabjerg,et al.  A Robust Control Scheme for Medium-Voltage-Level DVR Implementation , 2007, IEEE Transactions on Industrial Electronics.

[6]  Ralph Kennel,et al.  FPGA-basiertes Echtzeitrechner-System mit RTAI-Linux für Antriebssysteme , 2013 .

[7]  T. Boller,et al.  Replacement of electrical (load) drives by a hardware-in-the-loop system , 2011, International Aegean Conference on Electrical Machines and Power Electronics and Electromotion, Joint Conference.

[8]  G.G. Karady,et al.  A single-phase voltage sag generator for testing electrical equipments , 2008, 2008 IEEE/PES Transmission and Distribution Conference and Exposition.

[9]  Ralph Kennel,et al.  Development of a power-hardware-in-the-loop application — Power grid emulator by using ‘voltage source inverter cumulation’ , 2015, 2015 IEEE Applied Power Electronics Conference and Exposition (APEC).

[10]  Jaeho Choi,et al.  Improved digital control scheme of three phase UPS inverter using double control strategy , 1997, Proceedings of APEC 97 - Applied Power Electronics Conference.

[11]  Xin Wu,et al.  A Low-Cost Real-Time Hardware-in-the-Loop Testing Approach of Power Electronics Controls , 2007, IEEE Transactions on Industrial Electronics.

[12]  Jian Sun,et al.  Development of a grid simulator , 2012, 2012 IEEE 13th Workshop on Control and Modeling for Power Electronics (COMPEL).

[13]  Hirofumi Akagi,et al.  Active Harmonic Filters , 2005, Proceedings of the IEEE.

[14]  A. Monti,et al.  A new architecture for low cost Power Hardware in the Loop testing of power electronics equipments , 2008, 2008 IEEE International Symposium on Industrial Electronics.

[15]  Mariusz Malinowski,et al.  Hardware‐in‐the‐Loop Systems with Power Electronics: A Powerful Simulation Tool , 2014 .

[16]  Friedrich W. Fuchs,et al.  Laboratory type PWM grid emulator for generating disturbed voltages for testing grid connected devices , 2009, 2009 13th European Conference on Power Electronics and Applications.

[17]  Paolo Mattavelli,et al.  Synchronous-frame harmonic control for high-performance AC power supplies , 2001 .

[18]  M. Liserre,et al.  Stability improvements of an LCL-filter based three-phase active rectifier , 2002, 2002 IEEE 33rd Annual IEEE Power Electronics Specialists Conference. Proceedings (Cat. No.02CH37289).

[19]  M. Liserre,et al.  Design and control of an LCL-filter based three-phase active rectifier , 2001, Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248).

[20]  Dilip V. Sarwate,et al.  The frequency spectrum of pulse width modulated signals , 2003, Signal Process..

[21]  F. Blaabjerg,et al.  A detailed comparison of system topologies for dynamic voltage restorers , 2005, IEEE Transactions on Industry Applications.

[22]  Minwon Park,et al.  Design of a grid-simulator for a transient analysis of grid-connected renewable energy system , 2010, 2010 International Conference on Electrical Machines and Systems.

[23]  Ralph M. Kennel,et al.  Virtual machine — A hardware in the loop test for drive inverters , 2009, 2009 13th European Conference on Power Electronics and Applications.

[24]  J. K. Steinke,et al.  Use of an LC filter to achieve a motor-friendly performance of the PWM voltage source inverter , 1997 .

[25]  Eric Monmasson,et al.  FPGA Design Methodology for Industrial Control Systems—A Review , 2007, IEEE Transactions on Industrial Electronics.

[26]  Felix Lehfuss,et al.  Comparison of multiple power amplification types for power Hardware-in-the-Loop applications , 2012, 2012 Complexity in Engineering (COMPENG). Proceedings.

[27]  Michael Steurer,et al.  A Megawatt-Scale Power Hardware-in-the-Loop Simulation Setup for Motor Drives , 2010, IEEE Transactions on Industrial Electronics.

[28]  D.G. Holmes,et al.  An integrated approach for the protection of series injection inverters , 2001, Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248).

[29]  A. Monti,et al.  Methods for partitioning the system and performance evaluation in power-hardware-in-the-loop simulations - Part II , 2005, 31st Annual Conference of IEEE Industrial Electronics Society, 2005. IECON 2005..

[30]  F. Blaabjerg,et al.  Control and testing of a dynamic voltage restorer (DVR) at medium voltage level , 2003, IEEE Transactions on Power Electronics.

[31]  Wu Hong,et al.  Development of generator for voltage dips, short interruptions and voltage variations immunity test , 2002, 2002 3rd International Symposium on Electromagnetic Compatibility.

[32]  T. Friedli,et al.  Analysis of the design space of single-stage and two-stage LC output filters of switched-mode AC power sources , 2012, 2012 IEEE Power and Energy Conference at Illinois.

[33]  E. R. Collins,et al.  A three-phase sag generator for testing industrial equipment , 1996 .

[34]  G. H. Kwon,et al.  Voltage sag and swell generator with thyristor controlled reactor , 2002, Proceedings. International Conference on Power System Technology.