Scale formation in porous media and its impact on reservoir performance during water flooding

Abstract Water flooding is the most widely used improved oil recovery technique, and many other methods, such as chemical methods, are based on water flooding performance. If the injected water is not compatible with the formation water, scaling and other solid deposition would occur, which can reduce the formation permeability and transmissibility of the reservoir. The objective of this research is to model the in-depth reservoir formation damage as a result of scaling and to simulate its impact on reservoir performance. Literature survey shows that the development of a theoretical model for estimation of permeability and porosity reduction is of practical importance. In this paper, two models based on barium concentration were proposed to estimate permeability reduction in porous media as a result of scale deposition. Model development was conducted by using 216 experimental data points from literature covering various thermodynamic properties and reservoir conditions, and statistical and graphical error analyses were employed to evaluate the accuracy of the proposed models. The results showed that the proposed models are capable of predicting permeability alteration caused by scale deposition with absolute average relative errors less than 1% compared with the experimental data. In addition, the values of root mean square error and coefficient of determination were found to be nearly 0.1 and 0.95 for the high barium concentration model and 0.06 and 0.94 for the normal barium concentration model. Moreover, error distribution curves of the developed models showed that the models do not have any significant error trend under different reservoir and thermodynamic conditions. A synthetic field was used to simulate the injection and production performance of an incompatible water flooding operation to better study the impact of scaling issue on reservoir performance. In particular, the impacts of scale deposition on reservoir properties and injection pressure were investigated. The results of numerical simulation indicated that scale formation could reduce the reservoir porosity from 0.2 to nearly 0.07. Moreover, the injection bottom hole pressure needed for the operation increases significantly up to nearly 19,000 psi when the reservoir is affected by scale formation.

[1]  Li Li,et al.  Isotopic insights into microbial sulfur cycling in oil reservoirs , 2014, Front. Microbiol..

[2]  Reza Barati,et al.  Formation Damage in Iranian Oil Fields , 2002 .

[3]  J. J. Gallardo,et al.  An experimental and theoretical study , 2015 .

[4]  Ali Abouie,et al.  Development and application of a compositional wellbore simulator for modeling flow assurance issues and optimization of field production , 2015 .

[5]  Kenneth S. Pitzer,et al.  Thermodynamics of electrolytes. I. Theoretical basis and general equations , 1973 .

[6]  Amir H. Mohammadi,et al.  A smooth model for the estimation of gas/vapor viscosity of hydrocarbon fluids , 2015 .

[7]  R. Kharrat,et al.  Experimental and Theoretical Study of Calcium Sulphate Precipitation in Porous Media Using Glass Micromodel , 2009 .

[8]  F. Civan,et al.  Practical model for chemically induced formation damage , 1997 .

[9]  A. Putnis,et al.  The kinetics of barite dissolution and precipitation in water and sodium chloride brines at 44–85°C , 1993 .

[10]  Craig M. Bethke,et al.  Geochemical Reaction Modeling: Concepts and Applications , 1996 .

[11]  William D. Gunter,et al.  SOLMINEQ.88; a computer program for geochemical modeling of water-rock interactions , 1988 .

[12]  Catherine A. Peters,et al.  Accessibilities of reactive minerals in consolidated sedimentary rock: An imaging study of three sandstones , 2009 .

[13]  Mohammad Saber Karambeigi,et al.  Comprehensive management of mineral scale deposition in carbonate oil fields - A case study , 2014 .

[14]  C. Bethke.  Geochemical and Biogeochemical Reaction Modeling , 2007 .

[15]  H. L. Stone.  Probability Model for Estimating Three-Phase Relative Permeability , 1970 .

[16]  A. T. Kan,et al.  Validation of Scale Prediction Algorithms at Oilfield Conditions , 2005 .

[17]  Amer Badr Bin Merdhah,et al.  Scale formation in oil reservoir during water injection at high-barium and high-salinity formation water , 2008 .

[18]  Amir H. Mohammadi,et al.  Toward prediction of petroleum reservoir fluids properties: A rigorous model for estimation of solution gas-oil ratio , 2016 .

[19]  Amer Badr Bin Merdhah,et al.  Study of scale formation in oil reservoir during water injection-A review , 2007 .

[20]  A. Merdhah,et al.  Formation damage due to scale formation in porous media resulting from water injection , 2008 .

[21]  C. Blount.  Barite solubilities and thermodynamic quantities up to 300 degrees C and 1400 bars , 1977 .

[22]  H. Müller-Steinhagen,et al.  Scale Formation in Iranian Oil Reservoir and Production Equipment During Water Injection , 2003 .

[23]  S. Naseri,et al.  Effect of temperature and calcium ion concentration on permeability reduction due to composite barium and calcium sulfate precipitation in porous media , 2015 .

[24]  P. H. Sammon,et al.  Modeling CO2 Storage in Aquifers with a Fully-Coupled Geochemical EOS Compositional Simulator , 2004 .