Hardness assurance testing of bipolar junction transistors at elevated irradiation temperatures

The effect of dose rate on radiation-induced current gain degradation was quantified for radiation-hardened poly-Si emitter n-p-n bipolar transistors over the range of 0.005 to 294 rad(Si)/s. Degradation increases sharply with decreasing dose rate and saturates near 0.005 rad(Si)/s. The amount of degradation enhancement at low dose rates decreases monotonically with total dose. In addition, the effect of ambient temperature on radiation-induced gain degradation at 294 rad(Si)/s was investigated over the range of 25 to 240/spl deg/C. Degradation is enhanced with increasing temperature while simultaneously being moderated by in situ annealing, such that, for a given total dose, an optimum irradiation temperature for maximum degradation results. The optimum irradiation temperature decreases logarithmically with total dose and, for a given dose, is smaller than optimum temperatures reported previously for p-n-p devices. High dose rate irradiation at elevated temperatures is less effective at simulating low dose rate degradation for the n-p-n transistor than for the p-n-p transistors. However, additional degradation of the n-p-n device at elevated temperatures is easily obtained using overtest. Differences in the radiation responses of the device types are attributed to the relative effects of oxide trapped charge on gain degradation. High dose rate irradiation near 125/spl deg/C is found to be suitable for the hardness assurance testing of these devices provided a design margin of at least two is employed.

[1]  A. H. Johnston,et al.  A Total Dose Homogeneity Study of the 108a Operational Amplifier , 1979, IEEE Transactions on Nuclear Science.

[2]  R. L. Pease,et al.  Hardness-assurance issues for lateral PNP bipolar junction transistors , 1995 .

[3]  C. Kermarrec,et al.  A double-polysilicon self-aligned npn bipolar process (ADRF) with optional NMOS transistors for RF and microwave applications , 1994, Proceedings of IEEE Bipolar/BiCMOS Circuits and Technology Meeting.

[4]  P. V. Dressendorfer,et al.  A Reevaluation of Worst-Case Postirradiation Response for Hardened MOS Transistors , 1987, IEEE Transactions on Nuclear Science.

[5]  Ronald D. Schrimpf.  Recent advances in understanding total-dose effects in bipolar transistors , 1995 .

[6]  C. E. Barnes,et al.  Post-irradiation effects in CMOS integrated circuits (SRAMs) , 1988 .

[7]  C. Sah,et al.  Carrier Generation and Recombination in P-N Junctions and P-N Junction Characteristics , 1957, Proceedings of the IRE.

[8]  R. L. Pease,et al.  Comparison of ionizing-radiation-induced gain degradation in lateral, substrate, and vertical PNP BJTs , 1995 .

[9]  R. L. Pease,et al.  Hardness-assurance and testing issues for bipolar/BiCMOS devices , 1993 .

[10]  M. Gehlhausen,et al.  Elevated temperature irradiation of bipolar linear microcircuits , 1996 .

[11]  Allan H. Johnston.  The Application of Operational Amplifiers to Hardened Systems , 1977, IEEE Transactions on Nuclear Science.

[12]  C. Poivey,et al.  A compendium of recent total dose data on bipolar linear microcircuits , 1996, 1996 IEEE Radiation Effects Data Workshop. Workshop Record. Held in conjunction with The IEEE Nuclear and Space Radiation Effects Conference.

[13]  peixiong zhao,et al.  Physical mechanisms contributing to enhanced bipolar gain degradation at low dose rates , 1994 .

[14]  peixiong zhao,et al.  Physically based comparison of hot-carrier-induced and ionizing-radiation-induced degradation in BJTs , 1995 .

[15]  R. L. Pease,et al.  Trends in the total-dose response of modern bipolar transistors , 1992 .

[16]  Synergetic effects of radiation stress and hot-carrier stress on the current gain of npn bipolar junction transistors , 1994 .

[17]  J. R. Brews,et al.  The determination of Si-SiO/sub 2/ interface trap density in irradiated four-terminal VDMOSFETs using charge pumping , 1996 .

[18]  Arthur R. Hart,et al.  Hardness Assurance Considerations for Long-Term Ionizing Radiation Effects on Bipolar Structures , 1978, IEEE Transactions on Nuclear Science.

[19]  T. Carriere,et al.  Total dose effects on negative voltage regulator , 1994 .

[20]  Daniel M. Fleetwood,et al.  Charge separation in bipolar transistors , 1993 .

[21]  E. W. Enlow,et al.  Response of advanced bipolar processes to ionizing radiation , 1991 .

[22]  V. V. Belyakov,et al.  Use of MOS structures for the investigation of low-dose-rate effects in bipolar transistors , 1995 .

[23]  Ronald D. Schrimpf,et al.  Saturation of the dose-rate response of bipolar transistors below 10 rad(SiO/sub 2/)/s: implications for hardness assurance , 1994 .

[24]  Allan H. Johnston,et al.  Total dose effects in conventional bipolar transistors and linear integrated circuits , 1994 .

[25]  Mechanisms of ionizing-radiation-induced degradation in modern bipolar devices , 1991, Proceedings of the 1991 Bipolar Circuits and Technology Meeting.

[26]  R. Pease,et al.  Dependence of total dose response of bipolar linear microcircuits on applied dose rate , 1994 .

[27]  Daniel M. Fleetwood,et al.  Qualifying commercial ICs for space total-dose environments , 1992 .

[28]  H. Hughes,et al.  Short-Term Charge Annealing in Electron-Irradiated Silicon Dioxide , 1971 .

[29]  R. L. Pease,et al.  An improved standard total dose test for CMOS space electronics , 1989 .

[30]  F. V. Thome,et al.  High-temperature silicon-on-insulator electronics for space nuclear power systems: requirements and feasibility , 1988 .

[31]  R. L. Pease,et al.  A proposed hardness assurance test methodology for bipolar linear circuits and devices in a space ionizing radiation environment , 1997 .

[32]  peixiong zhao,et al.  Radiation effects at low electric fields in thermal, SIMOX, and bipolar-base oxides , 1996 .

[33]  Allan H. Johnston,et al.  Enhanced damage in bipolar devices at low dose rates: effects at very low dose rates , 1996 .

[34]  P. S. Winokur,et al.  Physical Mechanisms Contributing to Device "Rebound" , 1984, IEEE Transactions on Nuclear Science.

[35]  Harold L. Hughes,et al.  Determining the Energy Distribution of Pulse-Radiation-Induced Charge in MOS Structures from Rapid Annealing Measurements , 1972 .

[36]  Daniel M. Fleetwood,et al.  Using laboratory X-ray and cobalt-60 irradiations to predict CMOS device response in strategic and space environments , 1988 .

[37]  James M. Puhl,et al.  ACCELERATED TESTS FOR SIMULATING LOW DOSE RATE GAIN DEGRADATION OF LATERAL AND SUBSTRATE PNP BIPOLAR JUNCTION TRANSISTORS , 1996 .

[38]  Daniel M. Fleetwood,et al.  Hardness assurance for low-dose space applications (MOS devices) , 1991 .

[39]  A. Johnston,et al.  Models for Total Dose Degradation of Linear Integrated Circuits , 1987, IEEE Transactions on Nuclear Science.

[40]  R. L. Pease,et al.  Modeling ionizing radiation induced gain degradation of the lateral PNP bipolar junction transistor , 1996 .

[41]  Daniel M. Fleetwood,et al.  Strategies for lot acceptance testing using CMOS transistors and ICs , 1989 .

[42]  B. Johlander,et al.  Dose rate and annealing effects on total dose response of MOS and bipolar circuits , 1995 .

[43]  Allan H. Johnston,et al.  Enhanced damage in linear bipolar integrated circuits at low dose rate , 1995 .

[44]  Paul J. McWhorter,et al.  Modeling the anneal of radiation-induced trapped holes in a varying thermal environment , 1990 .

[45]  Charles E. Barnes,et al.  Accounting for time-dependent effects on CMOS total-dose response in space environments , 1994 .