Energy and exergy analysis of conventional acrylic solar still with and without copper fins

[1]  M. M. Younes,et al.  Improving the performance of trays solar still using wick corrugated absorber, nano-enhanced phase change material and photovoltaics-powered heaters , 2021 .

[2]  Gamal B. Abdelaziz,et al.  Enhancing the solar still performance via rotating wick belt and quantum dots nanofluid , 2021 .

[3]  A. S. Abdullah,et al.  Enhancement of pyramid solar distiller performance using reflectors, cooling cycle, and dangled cords of wicks , 2021, Desalination.

[4]  H. Panchal,et al.  Augmenting the productivity of stepped distiller by corrugated and curved liners, CuO/paraffin wax, wick, and vapor suctioning , 2021, Environmental Science and Pollution Research.

[5]  M. M. Younes,et al.  Enhancing the wick solar still performance using half barrel and corrugated absorbers , 2021, Process Safety and Environmental Protection.

[6]  A. Kabeel,et al.  Improving the tubular solar still performance using square and circular hollow fins with phase change materials , 2021 .

[7]  J. A. Esfahani,et al.  Improvement in the performance and cost of passive solar stills using a finned-wall/built-in condenser: An experimental study , 2021 .

[8]  M. M. Younes,et al.  Performance evaluation of a vertical rotating wick solar still , 2021 .

[9]  A. S. Abdullah,et al.  Experimental study on the performance of trays solar still with cracks and reflectors , 2021, Applied Thermal Engineering.

[10]  R. A. Beg,et al.  Combined influence of fin, phase change material, wick, and external condenser on the thermal performance of a double slope solar still , 2021 .

[11]  Ali J. Chamkha,et al.  Effect of fins and silicon dioxide nanoparticle black paint on the absorber plate for augmenting yield from tubular solar still , 2021, Environmental Science and Pollution Research.

[12]  M. Sadeghzadeh,et al.  Energy, exergy and economic investigation of passive and active inclined solar still: experimental study , 2021, Journal of Thermal Analysis and Calorimetry.

[13]  A. S. Abdullah,et al.  Experimental investigation of a new design of drum solar still with reflectors under different conditions , 2021 .

[14]  R. Sathyamurthy,et al.  Influence of fins on the absorber plate of tubular solar still- An experimental study , 2020 .

[15]  Mohamed Elashmawy,et al.  Enhancing tubular solar still productivity using composite aluminum/copper/sand sensible energy storage tubes , 2020 .

[16]  K. Sadasivuni,et al.  Experimental and water quality analysis of solar stills with vertical and inclined fins , 2020 .

[17]  A. Kabeel,et al.  Performance enhancement of pyramid-shaped solar stills using hollow circular fins and phase change materials , 2020 .

[18]  S. Ookawara,et al.  Evaluation of transparent acrylic stepped solar still equipped with internal and external reflectors and copper fins , 2020, Thermal Science and Engineering Progress.

[19]  K. Bataineh,et al.  Performance analysis of solar still integrated with internal reflectors and fins , 2020 .

[20]  Mohammad Israr,et al.  Effect of fin configuration parameters on performance of solar still: A review , 2020 .

[21]  A. Manokar.  Experimental study on effect of different mass flow rate in an inclined solar panel absorber solar still integrated with spiral tube water heater , 2020 .

[22]  H. Hassan,et al.  An experimental study on the performance of single slope solar still integrated with a PCM-based pin-finned heat sink , 2019, Energy Procedia.

[23]  A. Kabeel,et al.  Effect of Insulation on Energy and Exergy Effectiveness of a Solar Photovoltaic Panel Incorporated Inclined Solar Still—An Experimental Investigation , 2019, Solar Desalination Technology.

[24]  R. Sathyamurthy,et al.  Different parameter and technique affecting the rate of evaporation on active solar still -a review , 2018 .

[25]  D. Prince Winston,et al.  Sustainable fresh water and power production by integrating PV panel in inclined solar still , 2018 .

[26]  V. Sivakumar,et al.  MATLAB modelling and examination of the effect of heat capacity of basin and glass cover on performance of solar still by thermal models , 2018 .

[27]  D. Prince Winston,et al.  Integrated PV/T solar still- A mini-review , 2017, Desalination.

[28]  E. Ganapathy Sundaram,et al.  Assessment of convective heat transfer coefficient and mass of water evaporated from a single-slope passive solar still by different thermal models: an experimental validation , 2017 .

[29]  Habib Ben Bacha,et al.  Experimental performance analysis of a modified single-basin single-slope solar still with pin fins absorber and condenser , 2017 .

[30]  A. Manokar,et al.  Comparative study of finned acrylic solar still and galvanised iron solar still , 2017 .

[31]  W. M. Alaian,et al.  Experimental investigation on the performance of solar still augmented with pin-finned wick , 2016 .

[32]  V. Sivakumar,et al.  Energy and exergy analysis of single slope passive solar still: an experimental investigation , 2015 .

[33]  V. Velmurugan,et al.  Performance analysis of fin type solar still integrated with fin type mini solar pond , 2015 .

[34]  K. Kalidasa Murugavel,et al.  Different parameters affecting the rate of evaporation and condensation on passive solar still – A review , 2014 .