Propagation of a quasi-shear horizontal acoustic wave in Z-X lithium niobate plates [and conductivity sensor application]

It is found that an acoustic wave which is nearly polarized in the shear horizontal (SH) direction can propagate along the X axis of a Z-cut lithium niobate plate if the ratio h//spl lambda/, where h=plate thickness and /spl lambda/=acoustic wavelength, is less than about 0.5. Attractive properties of this quasi-SH wave include: (1) phase velocity nearly constant for all values of h//spl lambda/; (2) ability to propagate in contact with a liquid medium; and (3) electromechanical coupling coefficient as high as 0.15. These properties make the wave attractive for use in a variety of sensor and signal processing applications. An example of sensor applications is illustrated by using the wave to measure conductivity of liquids (aqueous KCl solution). The frequency of a 12-MHz quasi-SH mode oscillator fabricated on a 0.48 wavelength thick Z-X lithium niobate plate is found to vary by more than 80 kHz for variation in KCI concentration from 0 to 0.15%.

[1]  I. A. Viktorov.  Rayleigh and Lamb Waves , 1967 .

[2]  Antonio J. Ricco,et al.  Characterization of SH acoustic plate mode liquid sensors , 1989 .

[3]  J. Vetelino,et al.  Detection of nucleic acid hybridization with an acoustic plate mode microsensor , 1990, IEEE Symposium on Ultrasonics.

[4]  Richard M. White,et al.  Excitation and Detection of Surface Elastic Waves in Piezoelectric Crystals , 1969 .

[5]  F. K. Christensen,et al.  Improved laser processing of lithium niobate , 1994, 1994 Proceedings of IEEE Ultrasonics Symposium.

[6]  Shrinivas G. Joshi,et al.  Propagation of ultrasonic Lamb waves in piezoelectric plates , 1991 .

[7]  H. M. Gerard,et al.  Analysis of Interdigital Surface Wave Transducers by Use of an Equivalent Circuit Model , 1969 .

[8]  A. Ricco,et al.  Acoustoelectric interaction of plate modes with solutions , 1988 .

[9]  Richard M. White,et al.  A multisensor employing an ultrasonic Lamb-wave oscillator , 1988 .

[10]  C. Maerfeld,et al.  Theory and performance of acoustical dispersive surface wave delay lines , 1971 .

[11]  E. Adler,et al.  Propagation and Electromechanical Coupling to Plate Modes in Piezoelectric Composite Membranes , 1983 .

[12]  S. Joshi,et al.  Characteristics of ultrasonic Lamb waves in 128/spl deg/ rotated Y-cut lithium niobate , 1994, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[13]  S. Schreiter,et al.  Bulk wave membrane quartz resonators fabricated by a hollow cathode RF plasma etching technique , 1993, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[14]  H.-U. Poll,et al.  A new plasma-etching technique for micromechanical structuring of quartz , 1992 .

[15]  M. Grunze,et al.  Probing of strong and weak electrolytes with acoustic wave fields , 1992 .

[16]  B. Auld,et al.  Acoustic fields and waves in solids , 1973 .

[17]  S. Joshi,et al.  Excitation of higher‐order ultrasonic Lamb wave modes in piezoelectric plates , 1992 .