Characterization of embedded microheater of a CMOS-MEMS gravimetric sensor device

A CMOS-MEMS device for mass detection has been designed using 2008 CoventorWare software and fabricated using 0.35źm CMOS technology. This paper reports the characterization of the microheater and the temperature sensor embedded in the device. The measured resistances of the microheater and the temperature sensor were found to be close to the modeled values within ~4.2% error. The average temperature coefficient of resistance (TCR) of the temperature sensor of five dies was determined by increasing or decreasing the temperature in a range of 25°C-100°C. The resistance of the temperature sensor was found to increase with either an increase in ambient temperature or the voltage applied to the microheater, with a correlation factor of 0.99. The average TCR was found to be 0.0034/°C for the increasing temperature and 0.0036/°C for the decreasing temperature as compared to 0.0037°C reported in the literature, indicating an error of 8.1% and 3.5%, respectively. These differences between the measured and reported values are believed to be due to fabrication tolerances in the design dimensions or the material properties. The humidity was found to have a negligible effect on the resistance of the temperature sensor for increasing humidity levels from 40% to 90%. The repeatability of the measurements has shown low standard errors, which gives confidence in the reliability of the fabricated device.

[1]  Il-Doo Kim,et al.  Highly sensitive and selective acetone sensing performance of WO3 nanofibers functionalized by Rh2O3 nanoparticles , 2016 .

[2]  A. Javed Design, Microfabrication And Characterization Of A Microheater Platform For Studying DNA-surface Interactions , 2012 .

[3]  Siavash Pourkamali,et al.  A finite element analysis of thermoelastic damping in vented MEMS beam resonators , 2013 .

[4]  E. Domashevskaya,et al.  APPLICATION OF SEMICONDUCTOR GAS SENSORS FOR MEDICAL DIAGNOSTICS , 1999 .

[5]  Marc J. Madou,et al.  From MEMS to Bio-MEMS and Bio-NEMS: Manufacturing Techniques and Applications , 2011 .

[6]  Gian Carlo Cardinali,et al.  Development of ultra-low-power consumption MOX sensors with ppb-level VOC detection capabilities for emerging applications , 2008 .

[7]  Won-Hee Ryu,et al.  Selective diagnosis of diabetes using Pt-functionalized WO3 hemitube networks as a sensing layer of acetone in exhaled breath. , 2013, Analytical chemistry.

[8]  Philip J W Hands,et al.  Micro- and nano-structure based oligonucleotide sensors. , 2015, Biosensors & bioelectronics.

[9]  Sotiris E Pratsinis,et al.  Si:WO(3) Sensors for highly selective detection of acetone for easy diagnosis of diabetes by breath analysis. , 2010, Analytical chemistry.

[10]  X. Zhang,et al.  Determination of acetone in human breath by gas chromatography-mass spectrometry and solid-phase microextraction with on-fiber derivatization. , 2004, Journal of chromatography. B, Analytical technologies in the biomedical and life sciences.

[11]  Yin Zhang,et al.  Mass and Force Sensing of an Adsorbate on a Beam Resonator Sensor , 2015, Sensors.

[12]  Christopher J. Backhouse,et al.  Fabrication and characterization of aluminum thin film heaters and temperature sensors on a photopolymer for lab-on-chip systems , 2013 .

[13]  P. Zimmerman,et al.  Exhaled breath analysis for lung cancer. , 2013, Journal of thoracic disease.

[14]  M. Khir,et al.  Design, modeling and simulation of CMOS-MEMS resonator for biomedical application , 2014, 2014 5th International Conference on Intelligent and Advanced Systems (ICIAS).

[15]  David Zhang,et al.  A Novel Breath Analysis System Based on Electronic Olfaction , 2010, IEEE Transactions on Biomedical Engineering.

[16]  J. Andrew Yeh,et al.  A Sub-ppm Acetone Gas Sensor for Diabetes Detection Using 10 nm Thick Ultrathin InN FETs , 2012, Sensors.

[17]  M. H. Md Khir,et al.  Characterization of CMOS-MEMS device for acetone vapor detection in exhaled breath , 2015, 2015 IEEE Regional Symposium on Micro and Nanoelectronics (RSM).

[18]  Hailing Hu,et al.  Thermally assisted NO2 and NH3 gas desorption process in a polyaniline thin film based optochemical sensor , 2008 .

[19]  Ming Lei,et al.  Hard and soft micromachining for BioMEMS: review of techniques and examples of applications in microfluidics and drug delivery. , 2004, Advanced drug delivery reviews.

[20]  Yin Zhang,et al.  Mass and force sensing of an adsorbate on a string resonator , 2015 .

[21]  Kiyokatsu Jinno,et al.  Breath acetone analysis with miniaturized sample preparation device: in-needle preconcentration and subsequent determination by gas chromatography-mass spectroscopy. , 2009, Journal of chromatography. B, Analytical technologies in the biomedical and life sciences.

[22]  Christopher Walton,et al.  Breath acetone concentration decreases with blood glucose concentration in type I diabetes mellitus patients during hypoglycaemic clamps , 2009, Journal of breath research.

[23]  Milutin Stanacevic,et al.  Nanosensor Device for Breath Acetone Detection , 2010 .

[24]  Nancy M. McCurry,et al.  Aluminum temperature coefficient of resistance vs. grain structure , 1993 .

[25]  Mohammad Mohammadi Aghdam,et al.  Design and modeling of a novel translational and angular micro-electromechanical accelerometer , 2016 .

[26]  Chitsung Hong,et al.  Novel temperature sensor implemented on nanoporous Anodic Aluminum Oxide template , 2011, 2011 IEEE SENSORS Proceedings.

[27]  Pelagia-Irene Gouma,et al.  Ferroelectric WO3 Nanoparticles for Acetone Selective Detection , 2008 .

[28]  Darryl Hill,et al.  Breath Analysis for Medical Diagnosis , 2012 .

[29]  Russell Binions,et al.  Metal Oxide Semi-Conductor Gas Sensors in Environmental Monitoring , 2010, Sensors.

[30]  Paul Muralt,et al.  Bulk acoustic wave resonator operating at 8 GHz for gravimetric sensing of organic films , 2006 .

[31]  Pisana Placidi,et al.  Thermal characterization of a microheater for micromachined gas sensors , 2004 .

[32]  I. Elmi,et al.  Ultra Low Power MOX Sensors with ppb-Level VOC Detection Capabilities , 2007, 2007 IEEE Sensors.

[33]  D. Blake,et al.  Exhaled methyl nitrate as a noninvasive marker of hyperglycemia in type 1 diabetes , 2007, Proceedings of the National Academy of Sciences.