Investigation into the Fire Hazards of Lithium-Ion Batteries under Overcharging

Numerous lithium-ion battery (LIB) fires and explosions have raised serious concerns about the safety issued associated with LIBs; some of these incidents were mainly caused by overcharging of LIBs. Therefore, to have a better understanding of the fire hazards caused by LIB overcharging, two widely used commercial LIBs, nickel manganese cobalt oxide (NMC) and lithium iron phosphate (LFP), with different cut-off voltages (4.2 V, 4.5 V, 4.8 V and 5.0 V), were tested in this work. Some parameters including the surface temperature, the flame temperature, voltage, and radiative heat flux were measured and analyzed. The results indicate that the initial discharging voltage increases with the growth of charge cut-off voltage. Moreover, the higher the cut-off voltage, the longer the discharging time to reach 2.5 V. An overcharged LIB will undergo a more violent combustion process and has lower stability than a normal one, and the increasing cut-off voltage aggravates the severity. In addition, it is also revealed that the NMC fails earlier than the LFP under the same condition. The temperatures for safety vent cracking, ignition, and thermal runaway of LIBs exhibit similar values for the same condition, which demonstrates that the LIB will fail at a certain temperature. Finally, the peak heat flux, total radiative heat flux, and total radiative heat will rise with the increase in voltage.

[1]  Gi‐Heon Kim,et al.  A three-dimensional thermal abuse model for lithium-ion cells , 2007 .

[2]  Hiroaki Ishikawa,et al.  Cathode material comparison of thermal runaway behavior of Li-ion cells at different state of charges including over charge , 2015 .

[3]  E. Roth,et al.  DSC investigation of exothermic reactions occurring at elevated temperatures in lithium-ion anodes containing PVDF-based binders , 2004 .

[4]  Qingsong Wang,et al.  Thermal runaway caused fire and explosion of lithium ion battery , 2012 .

[5]  Rafael Bilbao,et al.  A model for the prediction of the thermal degradation and ignition of wood under constant and variable heat flux , 2002 .

[6]  Zhibo Wu,et al.  Heat release during thermally-induced failure of a lithium ion battery: Impact of cathode composition , 2016 .

[7]  Zhou Xiaodong,et al.  Experiment study of the altitude effects on spontaneous ignition characteristics of wood , 2010 .

[8]  Chong Seung Yoon,et al.  Comparison of the structural and electrochemical properties of layered Li[NixCoyMnz]O2 (x = 1/3, 0.5, 0.6, 0.7, 0.8 and 0.85) cathode material for lithium-ion batteries , 2013 .

[9]  Jie Ji,et al.  Effects of altitude and sample width on the characteristics of horizontal flame spread over wood sheets , 2012 .

[10]  R. Spotnitz,et al.  Abuse behavior of high-power, lithium-ion cells , 2003 .

[11]  E. Roth,et al.  Thermal abuse performance of high-power 18650 Li-ion cells , 2004 .

[12]  T. Fuller,et al.  A Critical Review of Thermal Issues in Lithium-Ion Batteries , 2011 .

[13]  Azah Mohamed,et al.  Hybrid electric vehicles and their challenges: A review , 2014 .

[14]  Azah Mohamed,et al.  A review of lithium-ion battery state of charge estimation and management system in electric vehicle applications: Challenges and recommendations , 2017 .

[15]  N. Sato.  Thermal behavior analysis of lithium-ion batteries for electric and hybrid vehicles , 2002 .

[16]  Yulin Ma,et al.  Degradation mechanism of over-charged LiCoO2/mesocarbon microbeads battery during shallow depth of discharge cycling , 2016 .

[17]  Pengjian Zuo,et al.  Capacity fading mechanism during long-term cycling of over-discharged LiCoO2/mesocarbon microbeads battery , 2015 .

[18]  Richard K.K. Yuen,et al.  Investigation of enclosure effect of pressure chamber on the burning behavior of a hydrocarbon fuel , 2016 .

[19]  V. K. Peterson,et al.  Overcharging a lithium-ion battery: Effect on the LixC6 negative electrode determined by in situ neutron diffraction , 2013 .

[20]  Salim Erol,et al.  Influence of overcharge and over-discharge on the impedance response of LiCoO2|C batteries , 2011 .

[21]  Mingyi Chen,et al.  Investigation on the thermal hazards of 18650 lithium ion batteries by fire calorimeter , 2015, Journal of Thermal Analysis and Calorimetry.

[22]  Christopher J. Orendorff,et al.  Thermal and Overcharge Abuse Analysis of a Redox Shuttle for Overcharge Protection of LiFePO4 , 2014 .

[23]  Takeshi Nakagawa,et al.  Thermal stability and kinetics of delithiated LiCoO2 , 2011 .

[24]  G. Venugopal.  Characterization of thermal cut-off mechanisms in prismatic lithium-ion batteries , 2001 .

[25]  Mingyi Chen,et al.  Study of the fire hazards of lithium-ion batteries at different pressures , 2017 .

[26]  Azah Mohamed,et al.  A review on energy management system for fuel cell hybrid electric vehicle: Issues and challenges , 2015 .

[27]  Heping Zhang,et al.  An experimental study on burning behaviors of 18650 lithium ion batteries using a cone calorimeter , 2015 .

[28]  Yiyang Li,et al.  Abuse tolerance behavior of layered oxide-based Li-ion battery during overcharge and over-discharge , 2016 .

[29]  Qingsong Wang,et al.  Enhancing the safety of lithium ion batteries by 4-isopropyl phenyl diphenyl phosphate , 2007 .

[30]  Viktor Hacker,et al.  Thermal runaway of commercial 18650 Li-ion batteries with LFP and NCA cathodes – impact of state of charge and overcharge , 2015 .

[31]  Dmitry Belov,et al.  Investigation of the kinetic mechanism in overcharge process for Li-ion battery , 2008 .

[32]  Wojciech M. Budzianowski,et al.  Negative carbon intensity of renewable energy technologies involving biomass or carbon dioxide as inputs , 2012 .

[33]  Zhiyong Liang,et al.  Overcharge failure investigation of lithium-ion batteries , 2015 .