Effect of superabsorbent polymers (SAP) on the freeze–thaw resistance of concrete: results of a RILEM interlaboratory study

This article presents the results of an interlaboratory experimental study performed by 13 international research groups within the framework of the activities of the RILEM Technical Committee 225-SAP “Applications of Superabsorbent Polymers in Concrete Construction”. Two commercially available superabsorbent polymers (SAP) were tested in terms of their influence on the freeze–thaw resistance of ordinary concrete. To test the robustness of the method, all participating laboratories used locally produced materials. Furthermore, following this aim, various accelerated methods were used to estimate the resistance of the concrete to freeze–thaw cycles. The effect of adding SAP was from insignificant to considerably positive in terms of improvement in material performance as determined by reduced mass loss after freeze–thaw cycles; only one participant observed worsening of the material behaviour. At the same time, due to the addition of SAP, a much less pronounced decrease in the dynamic Young’s modulus was observed as a result of freeze–thaw testing without deicing salt.

[1]  Marianne Tange Hasholt,et al.  Void structure of concrete with superabsorbent polymers and its relation to frost resistance of concrete , 2015 .

[2]  Pietro Lura,et al.  Controlling the coefficient of thermal expansion of cementitious materials – A new application for superabsorbent polymers , 2013 .

[3]  V. Mechtcherine,et al.  Relation between the molecular structure and the efficiency of superabsorbent polymers (SAP) as concrete admixture to mitigate autogenous shrinkage , 2012 .

[4]  Giovanni P. Terrasi,et al.  Reduction of fire spalling in high-performance concrete by means of superabsorbent polymers and polypropylene fibers: Small scale fire tests of carbon fiber reinforced plastic-prestressed self-compacting concrete , 2014 .

[5]  P. Lura,et al.  Superabsorbent Polymers — An Additive to Increase the Freeze-Thaw Resistance of High Strength Concrete , 2007 .

[6]  Viktor Mechtcherine,et al.  Effect of internal curing by using superabsorbent polymers (SAP) on autogenous shrinkage and other properties of a high-performance fine-grained concrete: results of a RILEM round-robin test , 2014 .

[7]  V. Mechtcherine,et al.  Effect of superabsorbent polymers (SAPs) on rheological properties of fresh cement-based mortars — Development of yield stress and plastic viscosity over time , 2015 .

[8]  V. Mechtcherine,et al.  Sorption kinetics of superabsorbent polymers (SAPs) in fresh Portland cement-based pastes visualized and quantified by neutron radiography and correlated to the progress of cement hydration , 2015 .

[9]  W. Weiss,et al.  Freeze Thaw Durability of Internally Cured Concrete Made Using Superabsorbent Polymers , 2014 .

[10]  Viktor Mechtcherine,et al.  Application of super absorbent polymers (SAP) in concrete construction—update of RILEM state-of-the-art report , 2021, Materials Structure.

[11]  P. Dubruel,et al.  Visualization of water penetration in cementitious materials with superabsorbent polymers by means of neutron radiography , 2012 .

[12]  M. J. Setzer,et al.  CDF test — Test method for the freeze-thaw resistance of concrete-tests with sodium chloride solution (CDF) , 1996 .

[13]  Yoichi Tsukinaga,et al.  Study on the test method for scaling resistance of concrete exposed to deicing chemicals , 2008 .

[14]  Jānis Justs,et al.  Internal Curing by Superabsorbent Polymers in Ultra-High Performance Concrete , 2015 .

[15]  P. Dubruel,et al.  Self-healing cementitious materials by the combination of microfibres and superabsorbent polymers , 2014 .

[16]  O. Jensen,et al.  Water-entrained cement-based materials: II. Experimental observations , 2002 .