Breakage of Spring Steel During Manufacturing: A Metallurgical Investigation

[1]  S. Dhua,et al.  Microstructural manifestations of fractured Z-profile steel wires on the outer layer of a failed locked coil wire rope , 2003, ASM Failure Analysis Case Histories: Buildings, Bridges, and Infrastructure.

[2]  Souvik Das,et al.  Breakage of electrode grade steel wires during manufacturing: A metallurgical investigation , 2019, Engineering Failure Analysis.

[3]  Souvik Das,et al.  Failure Analysis of Motor Tire Bead Wires During Torsion Test , 2013, Journal of Failure Analysis and Prevention.

[4]  Souvik Das,et al.  Failure analysis of steel wire of grade LRPC during drawing process , 2013 .

[5]  Sandip Bhattacharyya,et al.  Metallurgical investigation of different causes of center bursting led to wire breakage during production , 2013 .

[6]  Xiong Yan.  Study of the Microstructure and Properties of ER70S-6 Wire Rods , 2011 .

[7]  M. Založnik,et al.  Prediction of Macrosegregation in Steel Ingots: Influence of the Motion and the Morphology of Equiaxed Grains , 2009 .

[8]  Mario Rosso,et al.  MODELING OF CASTING , 2009 .

[9]  Industry updates , 2003 .

[10]  Ajoy Kanti Ghosh,et al.  Segregation in cast products , 2001 .

[11]  J. K. Brimacombe,et al.  The challenge of quality in continuous casting processes , 1999 .

[12]  J. Brimacombe.  The challenge of quality in continuous casting processes , 1999 .

[13]  S. Choudhary,et al.  Morphology and Macrosegregation in Continuously Cast Steel Billets , 1994 .

[14]  Z. Zimerman,et al.  Selection of Operating Parameters to Prevent Central Bursting Defects During Cold Extrusion , 1971 .

[15]  Ae Williams,et al.  Steel wire ropes , 1952 .